Transcript
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-27 RM Kit for Installation of One Unit
KIT CONTENTS •
Two short brackets
•
Four flat-headed screws •
Four washers
EQUIPMENT NEEDED •
A 3 mm Philips screwdriver
•
Four 5 mm Philips screws.
INSTALLATION
Warning
Disconnect all cables including the power cord from the unit before performing the installation procedures.
RM-27 rack mounting kit can be used for installation of RAD products in the 19-inch racks. ➤
To install the unit in 19-inch racks: 1. Attach a bracket to the side wall near the front panel of the unit (see Figure 1). 2. Fasten the bracket to the side wall using two screws and two washers provided. 3. Repeat steps 1 and 2 for the other bracket. 4. Fasten the brackets to the side rails of the 19-inch installation racks using four screws, flat washers and nuts (not supplied in the kit).
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-27 RM Kit for Installation of One Unit
Figure 1. Installing Unit in 19-inch Racks
http://www.cbnetworks.fr 2002 RAD Data Communications Ltd.
12 avenue des prés 78059 St Quentin en Yvelines Tel: 33 (0)1 77 55 03 00 Fax: 33 (0)1 30 44 11 95 E-mail:
[email protected]
190-217-09/02
Specifications are subject to change without prior notice.
