Transcript
AutoChanger
Quick Reference Guide Issue 2 - 22/07/2008
IMI Cornelius (UK) Ltd Tything Road, Alcester Warwickshire, B49 6EU Tel: +44 (0) 1789 763101 Fax: +44 (0) 1789 763644 www.corneliusuk.com IMI Cornelius reserves the right to modify the details in the publication as products and specifications are updated and improved. All data contained in this literature is correct at time of print.
AutoChanger
Quick Guide - LED Status & Action
AutoChanger from IMI Cornelius is an intelligent device that allows your beer to flow continuously, so when keg 1 runs out, keg 2 will kick in automatically, ensuring that your bar never runs dry. No need to dash down to the cellar to change a keg, no fobbing headaches, no priming the lines so no wasted beer – or profit.
LED
The system searches for where the supply is and eliminates the need for manual changeover during a busy serving period. AutoChanger caters for up to three pressurised kegs of a single product and can be retro-fitted. It saves time, maximises sales and is easy to operate and maintain.
Status
Meaning
Action
Constant Red
Ready to Dispense
None
Single Flash Red
Cleaning
None
Cleaning Halted
1. Simply check & vent Keg Out Monitor to continue 2. Cleaning will continue automatically and LED will ‘single’ flash again to indicate Cleaning mode
Key features Seamless transfer of keg supply no interruption mid-cycle Ease of operation & maintenance Standard cleaning regime no specialised training required Double Flash Red
Key Benefits Capable of providing continuous flow of beer Maximises serving potential & profits Takes the hassle out of regular manual keg changes every time a keg runs dry
Quick Guide - Normal Dispense & Cleaning
Quick Guide - AutoChanger Components 2
IMPORTANT NOTE:
6
Standard Parts 1. 3/8 JG Product Line connection to bottom of Keg Out Monitor 2. Bleed Valve 3. Indicator LED 4. Clean Button 5. Keg Cancel Button 6. 3/8 JG Product Outlet (Right hand outlet) 7. AutoChanger Casing
7 3 4
5 8
Additional Option (not shown) ##. Stand Off Mounting Bracket Additional Spare (Included as standard) 8. Gas Solenoid Kit
-
You should be shown how to use the AutoChanger by a suitably trained person AutoChanger uses kegs of the Same Product Type only
Normal Dispense - Product Connected -
System ready dispense (Indicator LED ‘Steady’ Red) To ensure continuous dispense replace at least one empty keg (of same product type) & manually prime…system will automatically seek for next available primed keg
1
Quick Guide - AutoChanger Installation IMPORTANT NOTE: -
Before you order your AutoChanger check mounting space in cellar AutoChanger has a mounting footprint of (Height) 285mm x (Width) 500mm Additional space is required around this footprint for product / gas connections If space limited you can order a Mounting Bracket as a option to be included with your AutoChanger AutoChanger is fully retrofittable into trade New or retrofittable installations must only be carried out by a suitably trained person System will be set-up with either product connected or if not with clean water connected
Normal Dispense – Clean Water Connected -
Simply Press & Hold ‘Clean’ Button and look for “Single” Flash on Indicator LED * Remove the three product keg couplers from cleaning system and connect ALL THREE to New or Part new kegs (of same product type)…..go to bar and dispense water until 100% product available Press & Hold ‘Clean’ Button until Indicator LED becomes ‘Steady’ Red & manually prime 3 lines (if required)
Cleaning -
Connect three product Keg Couplers to cleaning system & vent Keg Out Monitor / beer monitor (if used) Press & Hold ‘Clean’ Button until Indicator LED ‘Single’ flashes System is now in Cleaning mode and now available to clean as per standard cleaning process * Follow Clean Water Connected section above to ensure system is ready to dispense
