Transcript
Remote Keypad Option
Requires Quantum Data 800 Series video generator with firmware 2.998 or later.
Installation and Basic Operation Guide How to install keypad
How to uninstall keypad
1.
Shut off generator.
1.
Shut off generator.
2.
Connect keypad to serial port on generator.
2.
Disconnect keypad from serial port on generator.
3.
Hold down the Red video gate button while powering up the generator until keypad is displayed to configure generator for keypad operation mode.
3.
Hold down the Sync Gate buttons (ACS, DCS, and DSS) while powering up the generator until no special modes is displayed to configure the generator for normal operation mode.
Keypad mode reduces the baud rate to 1200 and disables the normal command parser. Front panel controls and indicators work as normal. The generator remains in keypad mode until you switch it to normal mode.
Normal mode key functions
Normal mode increases the baud rate to 2400 and enables the normal command parser, which enables the front panel programming mode.
Sequence mode key functions
Switch to Sequence Mode Select format Select image
Switch to Normal Mode Toggle display mode Cycle step mode
(Light on)
Esc
Tab
\
Num Lock
/
*
8
9
7
Pg Up
Home
4
5
6
1
2
3
End
(Light off)
Cycle R-G-B gating Previous format
+
Previous image Next format
Ins
Del
\
Num Lock
/
*
8
9
4
5
6
1
2
3
7
End
Enter
.
Tab
Pg Up
Home
Pg Dn
0
Esc
Next image Image invert toggle
Select sequence
+
Previous step
Pg Dn Enter
0
.
Ins
Del
Next step Select step
Task
Procedure
Task
Procedure
Select image from current list
Press * key, use numeric keys to specify the image number, and then press Enter.
Select sequence from current list
Press – key, use numeric keys to specify sequence number, and then press Enter.
Select next image
Press Enter.
Select any step in sequence
Select previous image
Press + key.
Press Del key, use numeric keys to specify step number, and then press Enter.
Select alternate version of image (if available)
Press Del key.
Select next step
Press Enter.
Change R-B-G video gating
Press – key to cycle through gating combinations.
Select any format from current list
Press / key, use numeric keys to specify format number, and then press Enter.
Select next format
Press 2.
Select previous format
Press 8.
Switch to Sequence Mode
Press Num Loc key.
Select previous step
Press + key.
Change sequence step method (step, wrap, auto, and so on)
Press * key to cycle through options.
Change DNUM settings
Press / key to cycle through options.
Switch to Normal Mode
Press Num Loc key.
© 2003 Quantum Data. Part 68-00165 Rev B Quantum Data, Inc. 2111 Big Timber Rd, Elgin IL 60123-1100, USA Tel (847) 888-0450 Fax (847) 888-2802 www.quantumdata.com
[email protected]
