Transcript
solidLUUV • recommended
english
weightsetup
CRE
ATED B
Y
F. B ERNARD
Olympus PEN E-P5 + accessories Explosion Drawing no setup
1. mount your camera Mount your camera on the cheese plate (d‘ont forget the top ring in between) by inserting the 1/4-inch screw in the hole (Fig. 2). Your camera must be securely fastened
Top ring
on the rubber part of the cheese plate and the lens must face the same direction as the nose of the cheese plate (Fig. 3).
Cheese plate ¼ inch screw
accessories
Weight cone screw
- CSS-S110 LS Leather Hand Strap on the right side - Lens Olympus 14-42 EZ
Small weight ring
Fig. 2
- Lens Cap Olympus LC-37C
Weight cone
Position of the ¼ inch screw on the cheese plate
Top funnel
2. add additional weights To find out if your camera requires additional weights, refer to the table below. Insert one or more additional weights to the top funnel or the base cap, and tighten them (Fig. 1).
Tip You can insert the small weight ring to either the top funnel or the base cap. In cases where you do not require additional weight in the top funnel, you can leave the weight cone screw in the box. The hat-shaped set screw and the rubber washer need to be inserted every time. Nose
Camera
Total weight
Additional weight for the top funnel
Additional weight for the base cap
Olympus PEN E-P5 + accessories
500 g + 535 g
-
Large weight ring
Adjustment ring
Fig. 3 cheese plate
Large weights Weightscrews Small weights Thread nuts Hat-shaped set screw Rubber washer Large weight ring
3. Position the weights
Base cap
Refer to the column “position” in the table below to determine the position of the weight screws A, B, C & D. With pushing the screws down guide each of them to the
Fig. 1
desired position (1-6), if required. Add the recommended number of small and/or large weights to weight screws A, B, C & D and tighten securely using the thread nuts. A Camera
Total weight
D
Number of weights1
Position
Number of weights1
Position
Number of weights1
Position
Number of weights1
1
9
1
16
3
10
4
12
The recommended amount of weight always refers to small weight plates.
Tip
community.luuv-stabilizer.com
C
Position
Olympus PEN E-P5
1
B
6 small weight plates = 1 large weight plate
Additional tips ·
The front lens of your 360° camera must face the same direction as the nose of
the cheese plate.
·
Make sure your camera is switched on and ready to operate (incl. batteries,
memory card, accessories, and if applicable, the zoom set to the correct setting
for filming).
·
Sometimes you need to change 1-2 small weight plates to another weight screw
or turn the adjustment ring a few degrees to reach the perfect equilibrium.
·
Watch our tutorial video for this Setup-Guide at community.luuv-stabilizer.com
