Transcript
TM
Wixey
Model WR25 Mini Digital Height Gauge
Patented US Patent no. 7,580,804
Instructions SAFTEY FIRST • •
Always turn off the power and unplug power tools before using any gauge. Never use power tools without properly installed blade guards. Guards may not be shown for clarity.
Readout Operation ON/OFF and ZERO
IN/MM
INCH MODE
MILLIMETER MODE
PUSH MOMENTARILY TO TURN OFF AND ON TOGGLES BETWEEN INCHES AND MILLIMETERS
HOLD FOR 3-5 SECONDS TO SET TO 0.000 (ABS MODE ONLY)
ABS/INC
ABSOLUTE MEASURING MODE
INCREMENTAL MODE RE-SETS TO 0.000
TOGGLE BACK TO ABS MODE AND THE CALIBRATED DIMENSION IS REMEMBERED
TOGGLES BETWEEN ABSOLUTE AND INCREMENTAL
Battery installation and locking the scale
Trouble Shooting Problem
INSTALL CR2032 BATTERY
Flashing Digits No Display
SCALE LOCK KNOB
No Display Erratic or Frozen Display
Possible Cause Low Voltage Low Voltage Bad Contact Internal Error
Solution Replace Battery Replace Battery Clean Battery Remove Battery Wait 1 Minute and Replace
Using the Gauge 1. Set the base of the Height Gauge on a flat reference surface and lower the scale until it lightly touches the surface. Set the display to 0.000
2. Set your or router bit or saw blades to the desired position as shown.
3. Install the plunger and zero the gauge for measuring depths as shown below
For more info on this and other Wixey products visit: www.machine-dro.co.uk
