Transcript
FT-1000MP Mark V Menu Settings Menu 0-1 0-2 0-3 04 0-5 0-6 0-7 0-8
Function Memory Group 1 Channels Memory Group 2 Channels Memory Group 3 Channels Memory Group 4 Channels Memory Group 5 Channels Quick Memory Channel Banks
1-8 1-9
[A > B] Auto Channel Up EDSP VFO-A & VFO-B Dial Speed Shuttle Jog Dial Speed IF SHIFT/WIDTH Step Size Main VFO-A Tuning Step Size SUB VFO-B Tuning Step Size Channel Step Size Quick Split Offset AGC Decay Time Automatic Selection CLAR M-Tune Function CLAR Tuning Step Size
2-0 2-1
Scan Pause Scan Resume Mode
0-9 1-0 1-1 1-2 1-3 1-4 1-5 1-6 1-7
2-2 2-3 2-4 2-5 2-6 2-7 2-8 2-9
3-0 3-1 3-2 3-3
Setting Range
Default
My Settings / Notes 1-5 WWV
1-99
99
0-99
OFF
0-99
OFF
0-99
OFF
0-99
OFF
1-5
5
ON/OFF
OFF
Not used ON
ON/OFF 2/4
ON 4
2
1Ms - 100Ms 10/20Hz
50 Ms 10 Hz
0.62(5)/1.25/2.50/5.00/10.00/ 20.00Hz 0.62(5)/1.25/2.50/5.00/10.00/ 20.00Hz 1 - 100kHz 1 - 100kHz ON/OFF
10.00Hz
ON/OFF 0.62(5)/I.25/2.50/5.00/10.00/ 20.00Hz ON/OFF CARSTOP/CARTIME/ CARSLOW
ON 10.00Hz
100Ms - 1000Ms(1s)
200Ms
1Ms - 100Ms
10Ms
OFF/GROUP1/GROUPSALL ON/OFF 1s - 10s A1 - A15 & B1 - B15 IF NOTCH/AUTO DSP/DSP SELECT
OFF OFF 5s A12 IFNOTCH
OFFSET/CARRIER 10Hz/100Hz/1000Hz(1kHz) CLAR/DIAL
OFFSET 10Hz CLAR
OFF/50/144/430
OFF
Set for CW and Fone sub-bands
5
10.00Hz 10 kHz 5 kHz OFF
5 ON
ON CARSTOP Not used
Memory Scan Speed (Dwell Time) VFO Scan Speed (Dwell Time) Auto Memory Write Memory Scan Skip Scan Delay Time Noise Blanker NOTCH Mode
Frequency Display Display Resolution ETS (Enhanced Tuning Scale) Transverter Frequency Display
1
Group 3 “OFF/OFF” typo B13 Don’t use DSP on CW – eliminates QRM and desired signal!
FT-1000MP Mark V Menu Settings Menu 3-4 3-5
Function Display Brightness Panel Display Mode
3-6 3-7
SUB VFO-B S-Meter MAIN VFO-A Meter Peak-Hold SUB VFO-B Meter Peak-Hold
3-8 3-9 4-0 4-1 4-2 4-3 4-4 4-5 4-6 4-7 4-8 4-9 5-0 5-1 5-2 5-3 5-4 5-5 5-6 5-7 5-8 5-9 6-0 6-1 6-2 6-3 6-4 6-5 6-6 6-7 6-8 6-9 7-0 7-1 7-2
Setting Range LOW/HI CLAR/CHFREQ/OFFSET/ CWPITCH ON/OFF OFF/10Ms – 2000Ms(2s)
ON OFF
1s
OFF/10Ms – 2000Ms(2s)
OFF
1s
200/75/10W
200W
ON/OFF 220 Hz – 7040 Hz or BEEP TUN ON/OFF 10/75/200W
ON 880 Hz
OFF/l/2/3/4
OFF
DVS RX Recording DVS PTT Control Headphone Audio AF GAIN Balance Control SSB Normal Filter nd 2 IF (8.2 MHz) 2.0kHzFilter CW Normal Filter nd 2 IF (8.2 MHz) DATA Narrow Filter rd 3 IF (455 kHz) rd 3 IF (455 kHz) rd 3 IF (455 kHz) SUB VFO-B RX Filter TX EDSP Filter RTTY Shift RTTY Polarity RTTY Tone Pair RTTY Frequency Display Packet Frequency Display Packet Tone Frequency
MAIN VFO-A/SUB VFO-B ON/OFF MONO/STEREO 1/STEREO 2 SEPARATE/BALANCE
MAIN VFO-A ON STEREO1 SEPARATE
8.2/455/8.2-455/OFF ON/OFF
OFF OFF
8.2/455/8.2-455 250HzFilter ON/OFF 8.2/455/8.2-455 2.0kHzFilter ON/OFF 500 kHz Filter ON/OFF 250 kHz Filter ON/OFF ON/OFF 6.0 kHz/2.4 kHz 170/425/850 Hz NORMAL/REVERSE HIGHTONE/LOWTONE CARRIER/OFFSET
8.2-455 OFF 8.2-455 OFF OFF OFF OFF 6.0kHz 170 Hz NORMAL HIGHTONE OFFSET
±3.000kHz
-2.125kHz
1170Hz/1700Hz/2125Hz/2210 Hz
2125Hz
CTCSS Tone Select Tone Mode Repeater Shift (TX OFFSET) Electronic Keyer Mode Keyer Dot Weighting Keyer Dash Weighting
67.0Hz - 250.3Hz CONTINUOUS/BURST 0 - 200kHz
88.5Hz CONTINUOUS
IAMBIC 1/BUG/IAMBIC 2 0(1:0.5) - 127(1:2.0) 0(1:2.0) - 127(1:4.5)
IAMBIC 1 10(1:1.0) 30(1:3.0)
RF Output Power (Limit) Key & Panel Beeper Key & Panel Beep Pitch Tuning Drive (Auto Power-Down) TX Audio EDSP
Default HI CLAR
My Settings / Notes CHFREQ – shows current memory freq
Not used Nice if this could also set 5/150 for contests OFF - annoyance
75W Seems best OFF with Heil mic Not used
“Narrow” typo
2.4 kHz
Not used
2
100kHz
If 7-0 IAMBIC 2 If 7-0 IAMBIC 2
FT-1000MP Mark V Menu Settings Menu 7-3 7-4 7-5 7-6 7-7
7-8 7-9 8-0 8-1 8-2 8-3 8-4 8-5 8-6
Function Keyer Contest Number Keyer Break-in Time Keyer Delay Time CW Playback Style EDSP Modulation & Demodulation
Sub Receiver Remote Control Function [FAST] key Operation LOCK Selection Split Operation Power Amplifier Frontend RF AMP Selection [ANT] Key Function USER Setting MODE Display Offset Receiver PLL Receiver Carrier Transmit PLL Transmit Carrier
8-7 8-8 8-9
Service Menu
Setting Range 0000 - 9999 0 Ms - 30 Ms 0.00s - 5.10s SSB (RX):100-3100Hz/ 300-2800 / OFF SSB (TX):100-3100Hz/ 150-3100Hz/200-3100Hz/ 300-3100Hz/OFF CW (RX):100-3100Hz/OFF
Default 0000 5Ms 0.00s Not selected OFF
Shortcuts: A=1 etc. 100-3100
OFF
300-3100
OFF
ON – AGC pulls on signal in passband
AM (RX):70-3800Hz/OFF ON/OFF KEYER/FRONT KEY/ VFO-A/VFO-B CONTINUOUS/TOGGLE DIAL/PANEL/PRIMARY NORM/AUTO/A=B ON/OFF TUNED/FLAT
OFF ON KEYER
AUTO/ON/OFF
AUTO
LSB/USB/CW(L&U)/ RTTY(L&U)/PKT ±5.000 kHz ±5.000 kHz 450.000 kHz - 460.00kHz ±5.000 kHz LSB: 456.300 kHz – 460.000 kHz USB: 450.000 kHz – 453.700 kHz PKT: 450.000 kHz – 453.700 kHz or 456.300 kHz - 460.000 kHz All others: 450.000 – 460.000 kHz ±5.000 kHz OFF/SSTV/FAX/PSK-31 AUTO/SLOW/FAST ON/OFF
LSB
TOGGLE DIAL NORM ON FLAT
AUTO – same mode TUNED
See Table See Table See Table See Table See Table
RTTY Offset See Table Easy Set OFF SUB RX AGC AUTO TUNER ON Carrier Offset RX LSB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz TX LSB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz PROC. LSB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz RX USB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz TX USB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz PROC. USB Carrier 0.200 kHz - +0.500 kHz 0.000 kHz TX AM Carrier 0.200 kHz - +0.500 kHz 0.000 kHz Turn on with FAST and LOCK depressed, then FAST and ENT for menu (Note: to be updated when a Technical Reference Manual is available)
3
My Settings / Notes
PSK31-USB
FT-1000MP Mark V Menu Settings Menu 9-0
9-1 9-2
Function Carrier Set
Setting Range
Default
RX LSB CAR TX LSB CAR PROC LSB RX USB CAR TX USB CAR PROC USB TX A3 CAR PROC A3
F 0.050 F 0.160 F 0.000 F 0.050 F 0.170 F 0.000 F 0.000 F 0.000 12
TIF-018 TIF-035 TIF-070 TIF-100 TIF-140 TIF-180 TIF-210 TIF-245 TIF-280 TIF-290
6 6 6 6 6 6 7 8 7 7
RX IF Amplifier Gain TX IF Amplifier Gain
9-3 9-4 9-5
Self Check
Rotate VFO-A to initiate light test
CPU-2.17
9-6 9-7
Linear graph indicator Transmit test cycle
ON/OFF ON/OFF
OFF OFF
Transmitter Receiver Band Change
1-240 secs 1-240 secs 1-BAND/ALL-BAND
1 1 1-BAND
Mode Change
1-MODE/ALL-MODE
1-MODE
Test Select Factory date TX select
START/END 4 hex bytes 00-FF JA/1/USA/JAIA/NEU-EU/S/ JARD1/JARD2/8/9/10/11/12/ NEU/-NCR/14/15/GEN
END 00092003 USA
9-8 9-9
My Settings / Notes
Not used Not used CONTOUR, VRF flash if selected, CLASS-A doesn’t flash Useful for checking out TVI reports TX cycle on time TX cycle off time If ALL, A and B antennas may be selected SSB requires tone input YYMMDD+rev?
This table is adapted from the Yaesu Mark-V FT1000MP Operating Manual and similar tables for the FT1000MP. The notes represent about two months’ experience with the unit chasing DX on CW and SSB. No optional filters or other modifications have been installed. Comments and suggestions to
mailto:
[email protected] 73, George VE3YV / K8HI 25 February, 2001
4
