Transcript
Concealed bath/shower mixer Installation Instruction Please read this instruction carefully to avoid any difficulty during installation.
Components List No.
Component
1
Handle
2
Plate
3
Sealing strip
4
Cap
5
Cartridge fastener
6
Ceramic cartridge
7
Cover
8
Main body
9
Female allen screw
10
Index
11
Knob
12
Diverting valve
13
Index
14
Cross-head screw
15
Plastic sleeve
16
O-ring
17
Stopper
18
Union
19
Safe cover for diverter
20
Safe cover for body
21
Index
22
Flat washer
23
Cross-head screw
24
Blue index
25
Red index
Quantity
1 1 1 1 1 1 1 1 1 1 1 1 1 2 2 1 1 1 1 1 1 1 1 1 1
Installation Step
Installation Fig
1 3
Flow rate Curves Test pressure: 1.6MPa (16bar)
L/min 40
Flow pressure:
35
2
1
4
Before installing the main body, read the index on cover , install the decorating tiles and glue the plate (4).
2
30
Min 0.05MPa
25
Max 1.60MPa
20
Recommended pressure:
15 0
0.5
1
1.5
2
2.5
3
3.5
4
Bar
0.1MPa to 0.8MPa (1 to 8 bar)
5
Note 7 6
3
Attention: the inner radii of the G1/2 connection pipe is not less than 13mm.
Read the Installation Fig and confirm the installing position.
Test: Open the supply pipes, close the ceramic cartridge and check the connections for leakage; open the ceramic cartridge and check the smooth water flow. Decorate the wall after checking and remove the safe cover. Install the escutcheon and handle.
1.Ensure proper cleaning of the water supply pipe before installation to avoid any jammed. 2.The cold-water supply must be connected on the right and the hot-water supply must be connected to the left. 3.Check the installation dimensions according to the Figure and ensure it is installed correctly. o
4.Hot-water inlet temperature must not be over 80 C. PZMF131400 2009.02.10
