Transcript
C - SPECIFICATIONS 1995 Volvo 850
1995 ENGINE PERFORMANCE Volvo - Service & Adjustment Specifications 850
INTRODUCTION Use this article to quickly find specifications related to servicing and on-vehicle adjustments. This is a quick-reference article to use when you are familiar with an adjustment procedure and only need a specification.
CAPACITIES BATTERY SPECIFICATIONS
Application 850
Cold Cranking Amp. Rating
...........................................
440 Or 520
FLUID CAPACITIES
Application Crankcase (Includes Filter) ......................... Cooling System (Includes Heater) .................... M/T (M56L) Volvo Synthetic Gearbox Oil (97308) ...... A/T (AW 50) (1) .....................................
Qts. (L) 5.6 7.6 2.2 8.0
(5.3) (7.2) (2.1) (7.6)
(1) - Use ATF Dexron IIE or Mercon fluid.
QUICK-SERVICE SERVICE INTERVALS & SPECIFICATIONS
REPLACEMENT INTERVALS
Component
Miles
Air Filter ........................................ 30,000 Timing Belt ....................................... 70,000 Coolant .............................................. ( 1) EGR Inspect ......................................... 60,000 Clean (2) ...................................... 100,000 Fuel Filter ....................................... 60,000 Oil & Filter Normal Service .................................. 10,000 Severe Service .................................... 5000 PCV (Inspect & Clean) ............................. 60,000 Spark Plugs ....................................... 30,000 (1) - Coolant replacement interval is no longer recommended by manufacturer. (2) - After 100,000 mile EGR service, clean every 20,000 miles.
BELT ADJUSTMENT
Application 850
Specification
..................................................
( 1)
(1) - No adjustment is necessary, vehicle is equipped with a self-tensioner.
MECHANICAL CHECKS ENGINE COMPRESSION
COMPRESSION SPECIFICATIONS
Application
Specification
Compression Ratio
.................................
10.5:1
VALVE CLEARANCE
NOTE:
Equipped with hydraulic lifters.
IGNITION SYSTEM IGNITION COIL
IGNITION COIL RESISTANCE - Ohms @ 68 F (20 C) Application Non-Turbo
Primary .....................
.5
Secondary
................
8400
SPARK PLUGS
SPARK PLUG TYPE
Application
Bosch
Non-Turbo
FR6DC
....................
Champion .............
RC9YC
SPARK PLUG SPECIFICATIONS
Application 850
.........
Gap In. (mm) .028-.032 (.70-.80)
Torque Ft. Lbs. (N.m) ..............
18 (25)
FIRING ORDER
Refer to illustration for firing order and distributor rotation. See Fig. 1.
Fig. 1:
Firing Order & Distributor Rotation
IGNITION TIMING IGNITION TIMING (Degrees BTDC @ RPM)
Application Non-Turbo
(1) Timing .................................
8-12 @ 750-850
(1) - Ignition timing computer-controlled. Not adjustable.
FUEL SYSTEM FUEL PUMP
FUEL PUMP PERFORMANCE (1)
Pressure Volume In 30 Sec.
Application 850
.............
psi (kg/cm )
43.5 (3.06)
Pts. (L)
................
1.1 (.52)
(1) - At 12 volts, 68 F (20 C), with engine off and fuel pump relay by-passed.
IDLE SPEED & MIXTURE
IDLE SPEED & CO LEVEL (1)
Application
Idle RPM
850
(3) 850
...............
(2) CO Level .................
(3) .2-.8%
(1) - Idle speed/CO level can only be checked, not adjusted. (2) - Measured upstream of catalytic converter with oxygen sensor connected. (3) - With cooling fan off.
FAST IDLE
NOTE:
All idle speeds are controlled by electronic control unit.
Specifications on fast idle not at time of publication.
THROTTLE SWITCH See the D - ADJUSTMENTS article for switch adjustments.
