Transcript
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-ACE-2002/P1 RM Kit for Installation of One Unit
KIT CONTENTS •
One short right side bracket
•
One short left side bracket (designated by an additional, fifth hole on the product mounting face of the bracket)
•
Four 5 mm Philips screws.
• Six screws
EQUIPMENT NEEDED •
A 3 mm Philips screwdriver
INSTALLATION
Warning ➤
Disconnect all cables including the power cord from the unit before performing the installation procedures. To install ACE-2002 in 19-inch racks: 1. Fasten the right bracket to the right panel near the front of the unit using the two screws provided (see Figure 1). You can also use an additional fastening point by removing a screw near the bracket mounting holes and securing the bracket by a third screw from the kit. 2. Repeat step 1 for the other bracket. 3. Fasten the brackets to the side rails of the 19-inch installation racks using four screws, flat washers and nuts (not supplied in the kit).
http://www.CBNETWORKS.fr - E-Mail:
[email protected] - Tel: 33 (0)1 77 55 03 00
Rack Mounting Kit for 19-inch Racks
RM-ACE-2002/P1 RM Kit for Installation of One Unit
Additional mounting hole
Figure 1. Installing ACE-2002 in 19-inch Racks
http://www.cbnetworks.fr 2002 RAD Data Communications Ltd.
12 avenue des prés 78059 St Quentin en Yvelines Tel: 33 (0)1 77 55 03 00 Fax: 33 (0)1 30 44 11 95 E-mail:
[email protected]
190-220-11/02
Specifications are subject to change without prior notice.
