Transcript
Installation Instructions 1. Remove the bolts from the right and left side of engine case as shown.
3. Install the glide plate by aligning the two tabs on either side of the engine case with the holes for the bolts that you just removed in step 1. 4. Thread the supplied 6x70mm bolts half way into the engine case
Mfg: TwoBros Make: Honda XR50 Year: All Product: Glide Plate (for cylinder without mounting tabs) Part # 010-8-18
Right side
Right side
Parts List Qty. 1 2
Description Glide Plate 6mm x 70mm Socket Head Cap Screws
Part Number 010-8-18 N/A
Left side
2. Remove all four bolts that hold the footpeg bracket and let it hang down
Left side
5. Press the glide plate up flush against the bottom of the engine case .
Warranty Warranty Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use of these products or parts.
6. Install the foot peg bracket over the skid plate. Use the stock bolts to secure. Only tighten the bolts finger tight. 7. Tighten the qty. 2 6mmx70mm engine case bolts to 8 ft. lb. 8. Tighten the qty. 4 foot peg bracket bolts in a criss-cross pattern to 19 ft. lb. 9. Check your work and your done 10. Re-check all fasteners after the first ride.
XR50R-Glide-Plate-NOTABS-Instructions.qxd
