Transcript
Charging Status:
Charging Status:
The Single Bay Battery Charger has an LED light to indicate the charging status of
The Single Bay Battery Charger has an LED light to indicate the charging status of
the reader. Once the reader is engaged with the charging clips - the LED will turn red
the reader. Once the reader is engaged with the charging clips - the LED will turn red
or green. (Figure 3)
or green. (Figure 3)
A red LED = reader/battery is charging
A red LED = reader/battery is charging
A green LED = reader/battery is fully charged*
A green LED = reader/battery is fully charged*
*Note: In certain reader configurations, the radio is required to
*Note: In certain reader configurations, the radio is required to
always be on, therefore requiring a constant power draw. In these
always be on, therefore requiring a constant power draw. In these
instances, while the power draw is minimal, the LED light may
instances, while the power draw is minimal, the LED light may
never turn green when charging a reader.
never turn green when charging a reader.
Figure 3
Figure 3
Installing the Single Bay Charger to the Wall Mount:
Installing the Single Bay Charger to the Wall Mount:
1. Attach the wall mount to a wall (because surface types differ, screws are not
1. Attach the wall mount to a wall (because surface types differ, screws are not
included to secure the wall mount to a wall).
included to secure the wall mount to a wall).
2. Using the two screws provided, follow the step shown in Figure 4 to install the
2. Using the two screws provided, follow the step shown in Figure 4 to install the
charger to the wall mount. Once the charger is installed, set a reader onto the
charger to the wall mount. Once the charger is installed, set a reader onto the
charging post to charge a reader. (Figure 5)
charging post to charge a reader. (Figure 5)
Figure 4
Figure 5
Figure 4
14870 S. Pony Express Rd. #200 Bluffdale, UT 84065 www.codecorp.com (801) 495-2200
14870 S. Pony Express Rd. #200 Bluffdale, UT 84065 www.codecorp.com (801) 495-2200 C003838_03_SingleBayBatteryCharger_Quickstart
© 2012 Code Corporation. All rights reserved.
Figure 5
C003838_03_SingleBayBatteryCharger_Quickstart
© 2012 Code Corporation. All rights reserved.
Quickstart Guide
Single Bay Charger
Quickstart Guide
Single Bay Charger
The Single Bay Charger features a charging bay
The Single Bay Charger features a charging bay
that can accommodate hand-held wireless
that can accommodate hand-held wireless
configurations of the CR2, CR2500, CR3 and
configurations of the CR2, CR2500, CR3 and
CR3500, with or without an Elastomer Boot.
CR3500, with or without an Elastomer Boot.
(Figure 1)
(Figure 1)
Figure 1
Figure 1
Included:
Included:
Charger and Power Supply (if ordered)
Wall Mount & 2 Screws to secure the charger to wall mount.
Charger and Power Supply (if ordered)
Wall Mount & 2 Screws to secure the charger to wall mount.
Charging a bar code reader:
Charging a bar code reader:
To begin, plug the power cord into the back of the charger, and plug the adapter into a wall socket.
To begin, plug the power cord into the back of the charger, and plug the adapter into a wall socket.
Figure 2
To charge a reader, simply place the reader,
To charge a reader, simply place the reader,
facing forward, onto the charging post. (Figure 2)
facing forward, onto the charging post. (Figure 2)
Note: Fully charge batteries before first use.
Note: Fully charge batteries before first use.
The approximate charge time is 4 hours.
The approximate charge time is 4 hours.
Figure 2
