Transcript
F400-13 A
Item – ref.
Subject
Date
530276
Changes In The Fan Motors In T24/35
May 2013
WARNING: • • •
Carry out the handling according to the following manufacturer's instructions. Always respect the warnings from the relevant manuals of the machines Make sure all electric power or other energy sources are disconnected and closed before any servicing. Always turn the main switch off. Wait 10 minutes after the electrical power is disconnected to purge the power from the inverter terminals. Installation, maintenance and service must be executed only by skilled service personnel or by a service organization with the appropriate authorization of the manufacturer For service, use only original replacement parts. Re-install all the machine parts in the original way The qualified agency performing this work assumes all responsibility for this kit installation. Other service activities than those described below, free the manufacturer from any liability. Make sure children are not around during work in progress.
• • • • • •
Dryers
Dryer Dryer Dryer Dryer
DAM(C)6 DA9, DAM(S)(T)9 T9 T11/13/16
T1313, TAM13 T24/35
DA11/13/15 DA1313 Applicable type of spare parts:
Dryer Dryer Dryer Dryer Dryer Dryer
D25/35 D55/77
General Chasis Cabinet Controler Coin unit
Heating unit
Motor / pulley / belts Bearing house & seals Air filter Air fan
MAIN REASON OF MODIFICATIONS:
Quality improvement. Noise reduction.
[email protected] www.primuslaundry.com
Drum Door Exhaust Electric components & sensors
DESCRIPTION OF MODIFICATIONS: The fan motor is newly fixed through a flange instead of foot. Old design – foot-mounted motor:
New design – flange-mounted motor:
Page 2 of 3
Item-ref.: 530276
SUMMARY: This modification concerns the fan motor, not the drive motor as in dryers with reversing option. The modification also applies in dryers without reversing option, since there is only one motor for both the fan and drive. It concerns both single-phase and three-phase motors. The single-phase motors are less noisy in this execution. The noise level of the three-phase motors was never considered high. Therefore, it remains within the original parameters, although a slight improvement might be present. New fan motors have a double shaft (one side for the fan impeller and the other side for the belt pulley as in the case of dryers without reversing option), regardless of their use in a machine with or without reversing. Motor 1-phase motor 3-phase motor
Old Part Number Reversing: 523722 Non-reversing: 523720 Reversing: 523723 Non-reversing: 523721
New Part Number 551783 523622
The old foot-mounted and new flange-mounted motors are not mutually replaceable, so consider this when ordering the spare parts. The new motors are used starting with the following serial numbers:
A. B.
Machine model T24 T35
Machine without reversing – one motor only
Page 3 of 3
Applicable serial number 24T005566XA 35T004331XA
Involved ECN ECN2531 ECN2531
Machine with reversing – two motors
Item-ref.: 530276
