Transcript
Smartline KVM Extender – Quick Guide SVX1 Packaging contents 1x SVX1 / PC 1x SVX1 / monitor 2x wall power supply 2x DVI-HDMI cable 1x USB cable 1x Quick Guide 4 mounting pads 4 rubber feet Installation: Connect the respective ports of your PC as shown below: SVX1/PC:
From the AC Adapter From the DVI output of the graphics card
kvm-tec electronic gmbh
– 2523 Tattendorf –
To the computer USB port
Josef Gisperg Platz 7 – Austria
Tel + Fax +43-2253 / 81912 – Mobil +43-650 81912 02 – Email
[email protected]
Cat5 cable to the monitor part of the Extender (up to 100m)
www.kvm-tec.com
SVX1/Monitor
The DVI input of the monitor
From the AC Keyboard adapter
Mouse
Cat5 cable to the PC part of the Extender (up to 100m)
Operation: Switch all devices on. In the first 5 seconds the units executes a cable adjustment, which is indicated by a slow flashing red LED. Once the status changes to green, all signals are transmitted. Settings: There are no adjustments necessary, the unit works by "plug and play".
kvm-tec electronic gmbh
– 2523 Tattendorf –
Josef Gisperg Platz 7 – Austria
Tel + Fax +43-2253 / 81912 – Mobil +43-650 81912 02 – Email
[email protected]
www.kvm-tec.com
Installation SVX2: The Smart Line SVX2 dual Extender installed just like SVX1. The SVX2 consists of 2 independent extenders. This creates additional flexibility in the application, as this provides 2 independent USB connections, even from different PCs. Here, the power supply on the left or right side is connected. The second DC port can be used for redundant power supplies as port. SVX2 Package Contents 1x SVX2 / PC 1x SVX2 / Monitor 2x wall power supply 4x DVI-HDMI cable 1x USB cable 1x Quick Guide 4 mounting pads 4 rubber feet
Requirements Cat5/6/7 cable: The pins are connected 1:1 Note: the cable pairs need to be connected according to EIA/TIA-568A or EIA/TIA-568 B Incorrect assignments can not be found with a simple cable tester. The pins for the green pair are not next to each other! The cable must be at least the Cat5 specification and be suitable for Gigabit transmission. Applicable standards: Class D of ISO / IEC 11801:2002 and EN 50173-1:2002.
Connection acc. to EIA/TIA-568 B Pin 1 2 3 4 5 6 7 8
color orange/white orange green/white blue blue/white green brown/white brown
Shielded installation cable min. 24AWG Screen continuously connected at both ends. Shielded patch cable as connection to the unit is allowed.
Mechanical Attachment: Optimum flexibility and security is achieved by using a 3M Dual Lock ™ fastening tape Type Type SJ-4570th This can also be used as a lower table side in the cabinet or for mounting in 19 "rack.
kvm-tec electronic gmbh
– 2523 Tattendorf –
Josef Gisperg Platz 7 – Austria
Tel + Fax +43-2253 / 81912 – Mobil +43-650 81912 02 – Email
[email protected]
www.kvm-tec.com
