Transcript
Anybus X-gateway - LonWorks Adapter Interface Product Overview
Network Installation Sheet
LED Indicators
The LonWorks Adapter interface can be top- or bottom-mounted. Both of these options are illustrated below.
Service Pin Button
LED
Indication
GW Status
See Gateway Installation Sheet
Meaning
Green
Top-mounted Interface
MS
Service Pin Button LonWorks Connector (X1)
Power Connector (X3)
Wink
Service
Gateway initialized and operating normally
Red
Hardware error
Red (flashing)
Software error - power-cycle gateway to recover
Red (flashing)
Wink command received
Off
Normal state
Green
Node is unconfigured and no application/errors detected by the Neuron self-test
Green (flashing)
Node is unconfigured and has an application
Off
Node is configured and installed on the network
The Service Pin Button is a pushbutton wired between the service pin and ground in the LonWorks connector. Pressing the button will send a service pin message on the LonWorks channel.
Remote Service Pin Pushbutton
Shield GND Service Net B Net A
Top-mounted
Bottom-mounted Interface Service Pin Button LonWorks Connector (X2)
GW Status
Accessories Checklist
MS Wink Service
The following items are required for installation: • LonWorks configuration tool (not included) • USB cable (included) • LonWorks cable (not included)
GW Status MS Wink Service
LonWorks Connector
1
5
Pin
Signal
1
Shield
2
GND
3
Service pin
4
NET B
5
NET A
USB (X4)
Installation and Startup Summary USB (X4)
Bottom-mounted
1. 2. 3.
Connect the gateway to the network Connect a PC to the gateway via USB (optional) Power up and (if required) configure the gateway
Technical Support Technical support, documentation and software downloads are available at www.anybus.com. Technical questions regarding the LonWorks fieldbus system should be directed to LonMark International at www.lonmark.org.
SP1750, rev. 2.00, Apr 2015
www.anybus.com
