Transcript
86037_3.fm Page 1 Tuesday, November 19, 2002 7:55 AM
ST60 Setup & Operation Cue Card Introduction This cue card provides a quick reference guide to the operation and calibration features of the ST290 Tridata instrument. Unless stated otherwise, all key presses are momentary. Operation
Current depth
Log
Boat speed
Trip
Shallow alarm threshold
Maximum speed Water temperature
2s to Reset
Deep alarm threshold
1s to Reset
Count-up timer
Average speed
1s to Reset
Race start timer 1 VMG to windward
2s to Reset
Anchor shallow alarm threshold
1s to Reset
Race start timer 2
1s to Reset
Anchor deep alarm threshold
To adjust a timer, simultaneously press AND to enter Adjust mode. In Adjust mode, use OR to set timer value. To leave Adjust mode, simultaneously press AND
86037_3.fm Page 2 Tuesday, November 19, 2002 7:55 AM
ST60 Setup & Operation Cue Card Illumination Enter Illumination Mode Hold down for 1 second Press repeatedly to cycle through settings Alarms Switch On/Off Hold down for 2 seconds Enter & Exit Adjust Mode Momentary while alarm value is displayed Adjust Increase value
Decrease value
Calibration User Calibration Depth Depth Units Depth Offset Shallow Alarm Lock
Intermediate Calibration Software Version Master/Repeater Selection (manual setting) Speed Calibration (auto)
Dealer Calibration User Calibration (On/Off) Speed Response (Fast/Slow) Depth Response (Fast/Slow) Boatshow Mode (On/Off) Factory Defaults (On/Off)
Speed Speed Units Speed Resolution Log Units Speed Calibration (SOG or manual) Temperature Units Temperature Calibration Time Beep (On/Off)
User Calibration Mode 2 seconds
Intermediate Calibration Mode 4 seconds Exit Calibration Mode & Save Changes 2 seconds
Document number 86037_3 (to be used with handbook: 81040_4) Date: 1st December 2002
Dealer Calibration Mode then 12 seconds
