Stainless Steel Specification

Transcript

Stainless Steel Specification Manufacturer: SSP Model Name: Place of Manufacture: Malta Drawing No: Astracast Ref.: Specification Revision Level: 1 Agean 1b Finish: Satin Sink Type: 1.0Bowl Item: Notes: Fixing system: 8 off screw clips as per SSP design (folded clip rail) Acoustic Pads: 2 off 110 x 160 mm pads to be attached to the bowl underside & drainer Waste hole(s): 1 x 90mmØ Tap hole(s): 2 x 35mmØ Pop up control hole: N/A Soap dispenser hole: N/A Overflow: Yes - Slotted Tap hole stopper: 1 off Stainless Steel Specification Scratch Protection: 1 x nitto sheet to be placed over the sink showface Reverse face finish N/A Earthing tag: 2 x 6.3mmØ hole on clip rail (at opposite ends) 1 x warning to be placed over the Waste warning waste 1 x Multi-lingual label on the bowl Product Care underside, over Acoustic pad. 1 x trace label to be placed on bowl Trace Label underside Product ID Product ID label Product labelling: Packaging: 1 x brown sleeve 1 x sink Malta Use Only 8 x clips Base Packing Specification: Accessory Pack Sealing strip Tap hole stopper Fitting Instruction / Guarantee Card Stainless Steel Specification QUALITY STANDARD FOR STAINLESS STEEL SINKS Visual Inspection Standard 1. All sinks must be visually 100% inspected during processing. 2. The sink should be viewed in from a distance of 0.8m ± 0.2m good light. 3. The polished areas of the show face shall be of a uniform appearance and shall not consist of any obvious dull areas. 4. The matte finish in the bowls must be of a uniform appearance and shall not consist of any obvious overly dull areas. Where the sink has two or more bowls the level of polish in the half bowl is to be consistent with the drainer finish. 5. 'Judder' marks from polishing should not be visible on the show face of the sink when viewed from a distance of 0.8m ± 0.2m in good light. 6. Minor surface scratches may appear on the show face, but the size and intensity of these scratches shall not be to the extent to make the product unappealing when viewed from a distance of 0.8m ± 0.2m in good light. Deep scratches are not acceptable. 7. There should be no material contamination. 8. Multiple defects should not appear within a 25mm radius of each other. Manufacturing Standard and Tolerances Apertures 1. All dimensions apertures should be sized and located as stated on technical drawings. 2. All apertures should be free from burrs. Sink Bow 1. When installed in a level worktop with all of the brackets tightened, there shall not be a gap of more than 1.0mm between the sink and the worktop at any point. Welds 1. All weld lines should be intact with no splitting. 2. All weld lines should be polished to ensure a uniform appearance across the sink. 3. There should be no pitting on the showface of welds. Clip Rail 1. The folded clip rail should be straight and free from kinks. Packing 1. Sinks should be clean and free from polish residue. 2. Sinks must be packed in line with the Astracast Specification. Stainless Steel Specification Trace Label 1 off standard trace label to be placed on underside of bowl Sleeve label Label format: TBC Care label 1 off label to be placed on outside bowl wall of every product.