Preview only show first 10 pages with watermark. For full document please download

Stand Alone Keypad - Kingdom Electronics

   EMBED

Share

Transcript

KINGDOM ELECTRONICS cc Electronic Design and Manufacture Security & Access Control Equipment PO Box 1940 • HONEYDEW • 2040 Tel: (011) 791 1362/3749 • Fax: (011) 791 6610 E-mail: [email protected] Website: www.kesa.co.za TECHNICAL DATA INFORMATION Stand Alone Keypad Connector Pin Layout FEATURES Ÿ Programmable master code Default = 1234 Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Seven programmable user codes Two independent relay outputs Relay times programmable in seconds or latch Wrong code lockout on 5th attempt Dual led indication, power and relay conditions Programmable 2 second delay before relay energises Surge protection Backlit keys Tamper switch 12VDC or 16 to 24VAC operation Entering Programming Mode – STAND ALONE KEYPAD (STEP 1) - Press and Hold - Wait for beep the release - Enter Master Code (Default Code – 1234) within 10 Seconds. Changing Master Code Changing Relay 1 Time Enter Programming Mode SEE STEP 1 Enter Programming Mode - Enter '0' then 'E'. - Enter '30' then 'E'. - Enter New Four Digit Master Code. Wait 2 beeps - Press to Save. - Enter amount of seconds required: 01 = 1 second 20 = 20 seconds 99 = latch mode - Press to Exit. - Press - Confirm (re-enter) The New Master Code. - Press Adding User Codes 1 to 6 Enter Programming Mode SEE STEP 1 to save setting. to Exit. Changing Relay 2 Time Enter Programming Mode - For User Code 1 -Enter '1' then 'E' followed by Four Digit User Code. - Enter '32' then 'E'. - For User Code 2 -Enter '2' then 'E' followed by Four Digit User Code. - Enter amount of seconds required: 01 = 1 second 20 = 20 seconds 99 = latch mode - Up to 6 different user codes can be added. - Press - Press 2 - Press to save, if code switches to RELAY 1 to save, if code switches to RELAY 2 - Press - Press to save setting. to Exit. to Exit. Switching ON / OFF Delay before Relay Energizes Enter Programming Mode Changing User Codes 1 to 6 - Same as adding user codes - Enter '40' then 'E' – to switch ON - 2 second delay before relay energizes. - Enter '50' then 'E' – to switch OFF - 2 second delay before relay energizes. - Press to save setting. - Press to Exit. Default Master Code by shorting NEG and DATA. (Unit will start to beep.) NB - Only release short, once Long Beep has sounded. Power OFF and then ON again, default will be back to code: 1234. LFT6 (Rev 1)