Transcript
START HERE
STEP ONE
WaterStrider
TM
FRONT (WIDE)
IN THE BOX
Red Stripe
1X MOUNT BASE 2X REAR 4X MOUNT 2X FRONT POD (SHORT) POD (LONG) STRAP WARNING
WaterStrider is not compatible with other accessories like LED lights, prop guards, camera protectors, gimbal guards, alternate landing gear, etc. Other accessories add additional weight, may affect flight characteristics, and may prevent proper installation of WaterStrider, which is critical for proper operation.
#DroneAnywhere
White Stripe
STEP TWO
STEP THREE
Snap the landing pods into the mount fittings.
Install 4x straps as shown by routing through the slots as shown. Fuzzy side
Insert fully until click White stripes on rear Red stripes on front
Be sure strap passes under bottom and not over the the top
STEP FIVE Pre-Flight Checks 1. Verify wider spread pods are toward the front. 2. Verify 4 snap fittings are clicked into place top & bottom. 3. Verify that Phantom gear legs are aligned & engaged into mount fitting pockets. 4. Verify all 4 hook & loop straps are firmly secured & Phantom gear legs cannot shift. 5. Visit dronerafts.com/tutorials for videos & app settings needed for best handling.
STEP FOUR Install WaterStrider onto Phantom.
P3
P4 Squeeze and pull strap tight
Wrap straps over the top of the gear leg and then down the inside and under the mount fitting.
P/N 100104
