Preview only show first 10 pages with watermark. For full document please download

Studio 5hpm - Fane International

   EMBED


Share

Transcript

THE PROFESSIONAL SERIES STUDIO 5HPM 5” / 127 mm 100 W (A.E.S.) 90 Hz - 7 kHz 1.5” / 38.1 mm 92.5 dB 4.5 mm Xmax CHASSIS DIAMETER AES POWER HANDLING FREQUENCY RESPONSE POLYAMID-IMIDE COATED COPPER VOICE COIL SENSITIVITY (1W/ 1m) MAXIMUM LINEAR EXCURSION n Smooth midband response with extended high frequency range. n Exceptional power handling from compact dimensions. Exceptional power handling and frequency coverage from compact dimensions. Primarily for full-range sound reinforcement and because of extended frequency response is also suited to multi-unit PA systems. Performance is optimised for mid range range singular / multiple use. ELECTRO ACOUSTIC SPECIFICATIONS THIELE SMALL PARAMETERS Nominal Chassis Diameter 5” / 127 mm FS Hz 164 Hz Impedance 4 Ohm / 8 Ohm / 16 Ohm RE Ohms 6.6 Ω Power Handling 100 W (A.E.S.) Qms 2.300 +100 Peak Power (6dB Crest Factor) 400 W (A.E.S.) Qes 0.715 +90 Usable Frequency Range -6dB 90 Hz - 7 kHz Qts 0.540 +80 Sensitivity (1 w - 1 m) 92.5 dB Vas Ltr 1.63 Litres +70 Moving Mass inc. Air Load 6.5 grams Vd Litres 0.045 Litres +60 Minimum Impedance Zmin 7.7 Ω CMS (mm/N) 0.148 mm/N Effective Piston Diameter 4.20” / 106.68 mm BL T/m 7.92 T/m FREQUENCY RESPONSE DATA† +120 dBr +110 +50 Hz 20 50 100 26 oz Mms (grms) 6.5 grams Magnetic Gap Depth 0.23” / 6.00 mm Xmax (mm) 4.5 mm Flux Density 1.42 Tesla Sd (cm2) 88 cm2 IMPEDANCE Coil Winding Height 0.51” / 13 mm Efficiency % 1.030% 200 Voice Coil Diameter 1.5” / 38.1 mm Le (1k Hz) 1.19 mH 100 EBP 229.37 Hz 5.25” / 133.35 mm Voice Coil Flange Height 0.27” / 6.9 mm Polyamid-imide Coated Copper Baffle Hole Diameter F/M 4.63” / 117.60 mm Magnet Material Ferrite Baffle Hole Diameter R/M 4.50” / 114.3 mm Chassis Die-cast Aluminium Gasket Supplied Front & Rear Cone Paper Surround / Edge Termination Polyvinyl Damped Multi Roll Linen Dust Dome Paper Connectors 0.125” Tab / Solder Polarity Positive voltage at red terminal causes forward motion of cone 4x Ø 0.218” on 5.468” PCD / 4x Ø 5.5 mm on 138.8 mm PCD Inner Fixing Holes N/A Depth 2.75” / 69.85 mm Weight 3.15 lb / 1.43 kg Recommended Enclosure Volume 0.07 - 0.35 cu ft / 2 - 10 Litres Shipping Weight 3.65 lb / 1.66 kg Packing Carton Dimensions (W) 160 (D) 160 (H) 110 mm 10 5 2 1 Hz 20 2.75” / 69.85 mm Outer Fixing Holes 20 50 100 200 1k 500 2k 5k 10k 20k m Width Across Flats 50 m Resin Bonded Glass Fibre 20k .4 Former Material 10k 52 6” / 152.4 mm 5k Ohms /1 Overall Diameter 2k 3.94” / 100 mm 5.25” / 133.35 mm MATERIALS OF CONSTRUCTION 1k 500 † Half space response measured in a 975 Litre sealed box. Magnet Weight MOUNTING / SHIPPING INFORMATION 200 6” THE PROFESSIONAL SERIES STUDIO 5HPM | FULL RANGE DRIVER FULL RANGE DRIVER * Please enquire about alternative impedances. * A.E.S. power handling test. Pink noise bandpass filtered at 12 dB per octave with cutoff frequencies of 50 Hz and 500 Hz. Driver mounted in free air, test signal applied at rated power for two hours. * Please note that the frequency response measurements are supplied for comparison only and are not a measure of the low frequency performance which may be achieved in a fully optimised system. © 2016, Fane International Ltd. We operate a policy of continuous research and development and as such published specifications are subject to change without notice. www.fane-international.com 230316