Transcript
Ethernet to E1 Converter
- SVPE48 Series
SVPE48 Series, Inverse Multiplexer, are worked as network termination units for connecting Fast Ethernet over multiple (4xE1) bonded E1 circuits. These devices can build scalable, virtual and steady large pipe from individual E1. It is available as a standalone unit or inserted as a module card into a chassis CHAS02. Fast and easy deployment, remote and convenient management, all of these advantages will be reducing investment of carriers and ISPs.
SPECIFICATIONS 10/100Base-Tx
• 4*10/100Base-Tx Auto-negotiation Duplex • Compatibility: Relevant sections of IEEE802.3x; IEEE-802.3u • Connector: RJ45 • Data rate: 10/100M Auto-negotiation
FEATURES 10/100Base-Fx • Provide from 4 x E1 with 75ohm unbalanced or 120ohm balanced interface. • Maximum 4x10/100Base Tx and 100Base Fx are available. Support local swithcing and isolated port based on VLAN functions • Selectable data rate based on ports • Available priority function based on IEEE802.1p • Compliance to IEEE802.3x–flow control for PAUSE Frame • Suppress broadcast storm • Support VCAT function based on ITU G.7043. Auto-adapt
• 100Base-Fx Full Duplex • Transmitter optical power: -3dbm~8dbm • Receiver sensitivity: -33dbm~-40dbm • Connector: SC or FC optional E1 Interface
• Bit Rate: 2048Kbps • Line Code: HDB3 • Line Impedance: 75ohm unbalanced or 120ohm balanced • Electrical Characteristic: ITU-T G.703 • Jitter Performance: ITU-T G.823 • Connector: BNC unbalanced; RJ45 balanced
the maximum 240ms time delay difference • Support SNMP and Console management and upgrade software online • Support Traffic load balance and Fault self recovery functions on E1 circuits.
Management Port
Console Port • Interface: RS-232 • Connector: RJ45 • Baud rate: 57600bit/s
• Support loop-back on E1 circuits. • Support priority and flow control to guarantee better Qos based on VLAN and IEEE802.1q TAG QinQ VLAN functions • Compliance to ITU G.8040 standard- mapping GFP into load of PDH; • AC or DC or Universal Power supply
General • Power Supply AC: 220VAC±20%; 50HZ DC: 24VDC or -48VDC • Power Consumption ≤ 10W • Working Environment Temperature: 0°C~45°C Humidity: Up to 90% non-condensing
APPLICATION
In this point to point application, SVPE is acted as network termination units (NTUs) for connecting LANs over multiple bonded E1 circuits. The SVPE provide 4 x E1 and one, two or four Ethernet. NMS are available for both central rack and standalone option.
ORDERING INFORMATION SVPE48
Standalone; 4*10/100Base-Tx to 4*E1 Converter; SNMP management; 220VAC or -48VDC
SVPE48x
Standalone; 1*10/100Base-Fx and 4*10/100Base-Tx to 4*E1; SNMP management; 220VAC or -48VDC
KSVPE48
Module Card; 4*10/100Base-Tx to 4*E1 Converter; SNMP management
KSVPE48x
Module Card; 1*10/100Base-Fx and 4*10/100Base-Tx to 4*E1; SNMP management
