Transcript
Talking Clock with EZ Talk Button Item: 835888 INSTRUCTIONS Buttons on Clock On bottom right side, largest button on clock, which is Green: Talk button to announce time Mode button: changes between modes Hour button: changes hours for setting time and alarm Minute button: changes minutes for setting time and alarm Volume control: controlled by a switch. Switch is to the left of the Mode button. Switch, has position on left is low volume and position on right is high Clock is in a rectangular shape, Time button on far right, Mode, Hour and minute button in the order of: Mode, Hour, Minute These three buttons are located to the left of the talk button. Volume control is at the far left of the clock. To announce the time Press THE TALK BUTTON (GREEN, AT FAR RIGHT OF CLOCK) to hear the time announcements. Slide the VOLUME switch (AT FAR LEFT OF CLOCK) to change voice volume. To set 12H/24H time format 1. In the time-display mode, press the MODE button once to enter the 12/24hour-setting mode. 2. Press the Hour button to set the time telling mode to "12 Hour" or press the MINUTE button to set "24 Hour, (military time)". 3. Press the MODE button twice until the mode beeps three times to return to the Time-display mode. Note: During setup, if no key is pressed for more than 30 seconds, the clock will return to Time-display mode. To set the time Press the Mode button once. Press the Hour button until you reach the correct hour. Press the minute button to set the correct minute. Press the Mode button twice to return to the time setting mode. To set the alarm time Press the Mode button twice to set the alarm. Press the Hour button until you reach your desired hour for your alarm. Press the minute button to set the minutes for your alarm. Press the Mode button once to return to the time display mode. To turn on and off the alarm To turn on the alarm, press the HOUR button once. when turning on the alarm, the clock will beep three times and announce the time your alarm is set for. When turning it off, it will beep once, which means the alarm is off.
At the preset alarm time, the alarm sounds for 60 seconds. To silence the alarm sooner, press any key, thereafter the alarm repeats five times in every five minutes. You can do the following during alarm sounding. (A) Press the MODE button: this turns off the snooze function( " SNZ " stops flashing ) - and the alarm will not sound again until next day at the preset time. (B) Press HOUR: this terminates the snooze and the alarm completely, and you need to set up the alarm over again. To turn on and off hourly time announcement This clock can automatically announce the time every hour. To turn on the hourly time announcement, press the MINUTE button once. The clock will beep three times. To turn off hourly announcement, press the minute button once. The clock will beep once. To replace the battery this clock uses two "AA" batteries for power. When the LCD dims, sound weakens or function is abnormal, replace the battery, follow these steps: 1. Remove the back cover. 2. Remove the old battery and install a new one with the "+" polarity facing up. 3. Replace the back cover. For any technical support, please contact: Magnifying Aids: Email:
[email protected] Phone: (727) 526-2020
