Transcript
EX90 is delivered with:
Cisco TelePresence System EX90 installation guide
• • • • •
EX90 unit Touch screen with cable Handset base with cable Handset AC adapter and power cable • Screwdriver
User documentation Cables: • DVI-D to DVI-I cable (recommended for optimal PC image quality) • VGA to DVI-I cable • Stereo audio cable 3.5 mm • Ethernet cable
The user documentation for this product, including compliance and safety information, is found on the Cisco web site. Go to: http://www.cisco.com/go/ telepresence/docs.
2
Unpacking the EX90 unit
Place the package on the floor with broad side down. Grasp the EX90, surrounded by foam protection, and pull it out of the package.
• Cleaning cloth
1
Unpacking the touch screen and cables Lift out the rectangular box from the package. In the box you will find cables, and another box with the touch screen and handset. Unpack the touch screen with the handset and handset base.
Handset base
Handset Carefully loosen the foam protection. Lift out the EX90 and place it on a firm surface. Weight: 14 kg / 31 lb Cables
Touch screen
EX90 78-19788-02 EX90 Installation Guide | April 2011 | © 2010 Cisco Systems, Inc. All rights reserved.
3
4
Optional: Mounting the handset Tool: Screwdriver
A
B
Take the touch screen and the handset base and hold the two units in an upright position.
5
System overview and basic setup
Connecting a PC
Fasten the two units together. The screws are pre–mounted in the handset base.
Use the screwdriver and fasten the screws at the handset base from the underneath.
Move the two units together. Make sure the protruding contact on the handset base slides into the corresponding hole on the touch screen.
Optional PC connection, RJ45 Remove the cover to get access to the connectors at the rear side.
Touch screen
Kensington lock
Micro- Headset phone
Handset base
2 x USB
Cables
If you have a single LAN wall outlet only, you may connect your PC to the PC-socket of EX90. Your PC and the EX90 will then share the LAN connection.
The cables are found in the long rectangular box, see the previous page.
6
Scale 1:1
Starting the system Camera LED
C
Optional HDMI output
Optional PC video input
Camera • Turn to open/close the privacy cover. • Tilt downwards to use as document camera.
Scale 1:1
For future use
Audio from PC, Stereo cable 3.5 mm mini jack
The optional PC connection
Scale 1:1
Optional PC connection
Video from PC, DVI-I cable
Optional PC audio input
Connect the handset to the handset base, and connect the handset cable.
Power LED
Local area network (LAN)
Touch screen
Optional HDMI input
Power supply (use the supplied AC adapter)
Please read the user documentation, which is available on the Cisco web site, for further information about how to set up and use your system.
Power button • Tap the power button once to switch on/ off the monitor. • Press gently and hold the power button to shut down the system.
