Transcript
TECH BULLETIN IBnstallation attery Testing Instructions Specifications
AKT0002
USED ON GAS AND DIESEL MODEL TRACTORS
+
NOTE: Do Not Polarize the Alternator
rt)
o (Sh
Or
Terminal Block (NOT IN KIT)
+
NOTE: INSTALL BATTERY AS NEGATIVE GROUND ONLY
R (no e-Us ts eW up ir pli e ed ) Re-U s (not e sup Wire plie d)
ge
an
ire
W
Starter Solenoid
Coil
ow
W
On 1953 and 1954 NAA Models and some 1955 and up 600 Series, cut the orange wire out and discard it.
Starter Switch
Ignition Key
Cable not supplied
-
ire
Resistor #IDR6000
Ye ll
ire
W ite
h
+
re
e Wi
Whit
Terminal #1 under cap ALTERNATOR #ADR0188
W
Red
e Wir
AMMETER
Red W ire (From Loom)
Battery Terminal
Red Wire
+
12 VOLT BATTERY
NEGATIVE GROUND
-
1. Disconnect the BATTERY CABLES from the BATTERY in the tractor. 2. Remove the existing generator, voltage regulator, all mounting brackets, and the wiring that connects the components shown on this page. 3. Install Alternator Mounts. 4. Next the Alternator can be installed. 5. The wiring harness now can be installed. Notice the routing diagram to the right of this page. 6. Next Install a 12 VOLT BATTERY - IT MUST BE INSTALLED AS NEGATIVE GROUND. 7. All lights MUST be changed to 12 Volt bulbs.
Mount #GFD9306
8. Check to see if there is power at the Battery Terminal on the back of the Alternator. This should be “HOT” all the time. 9. Now start the tractor and increase engine speed until the alternator starts charging. It may be necessary to go to full throttle to attain engine charge. If the alternator does not charge, re-check all steps. 10. If manual excitation of the alternator is necessary, momentarily feed battery power to the #1 terminal in the plug (remove the plug cover) using a jumper wire attached to the alternator battery stud.
MAIN LOCATION
(800) 328-5454
EAST COAST
(855) 214-0712
WEST COAST
(800) 457-1728
CANADA
(877) 617-2888
Mount #GFD9307
WE KEEP YOU RUNNING
