Transcript
ROS REVERSE OSMOSIS WITH DEIONIZER AND 55 GAL STORAGE TANK MODEL 00HCB-2045
Healthcare Water Treatment Systems Technical Data Sheet
APPLICATION: Provides low conductivity water for washers, disinfectors, glassware washers, steam boilers and final rinses. DESCRIPTION: Reverse Osmosis System and deionizer polisher with all pretreatment on board in a PVC cabinet and a 55 gallon storage tank with demand pump package that provides up to 20 GPM, and up to 800 GPD (see reverse side for sizing information). Deionizer polisher utilizes exchange mixed bed resin packs. FEATURES: • Pre-carbon block filter • Anti-scalant feed to prevent hard water scale on reverse osmosis • Controller with conductivity of feed and product water • Simple disinfection cycle • Low feed pressure shut down • Storage tank with sealed lid and pump package • Deionizer polisher includes a 200,000 ohm-cm monitor with alarm CERTIFICATIONS: • ETL listed to UL 61010-1 and CSA C22.2 No. 61010-1 • Seismic OPA-2202-07 • ISO134585 registered device • FDA cleared for marketing PRINCIPLE OF OPERATION for COMPLETE WATER TREATMENT SYSTEM:
Tap water enters the system through the filters, after which the anti-scalant chemical is pumped into the flow to the reverse osmosis pump and membranes. Product water flows through the deionizer and monitor, to the 55 gallon storage tank, reject concentrated waste water flows to the drain (product and reject are 50% each). The demand pump runs when flow is needed and pumps the low conductivity water to the use. SAFETY FEATURES: • Low feed pressure system shutdown / alarm • High conductivity alarm • Storage tank empty pump shutdown
AmeriWater • 1303 Stanley Ave, Dayton, OH 45404 • 800-535-5585 • www.ameriwater.com • 4/12
ROS REVERSE OSMOSIS WITH DEIONIZER AND 55 GAL STORAGE TANK MODEL 00HCB-2045
Healthcare Water Treatment Systems Technical Data Sheet
INPUT REQUIREMENTS: Recommended Space for Installation System Dimensions Drain Feed Water Quality Feed Water Temperature Feed Water Flow Minimum Feed Water Pressure Minimum Electrical Receptacles
86” L x 66” D 62” L x 30” D x 62” H One 1-1/2” floor drain or sink Potable drinking water standards Between 41° - 90° F (Ideal 77°) 3 GPM 20 PSIG (2) 115 volt AC / 20 amp dedicated circuits Three prong
INSTALLATION: The system can be installed with up to 50’ of pipe from the use. Subtract 2’ for each elbow in the pipe from the 50’ length. If the piping is greater than 50’ or if there is need for more pressure or flow rate, the high flow storage tank system should be used. SPECIFICATIONS / PERFORMANCE: Shipping Weight Operating Weight Production Rated Capacity* Distribution Pump Output
457 lbs 925 lbs 800 GPD / 3,028 LPD 20 GPM @ 20 PSI
* Product flow rate varies with temperature and inlet pressure. All models are rated at 77°F with feed water of 1500 mg/l NaCl @ 55 PSI feed pressure and pH of 7.5. As a safety factor, use 60% of the rated capacity when sizing or add a blend valve to temper the feed water.
WARRANTY: One year on parts. ACCESSORIES: Remote alarm package 1 megohm monitor w/alarm for deionizer Blend valve assembly
Part #00850233 Part #75679117 Part #00HCB-5001
AmeriWater • 1303 Stanley Ave, Dayton, OH 45404 • 800-535-5585 • www.ameriwater.com • 4/12
