Preview only show first 10 pages with watermark. For full document please download

Technical Bulletin Tbjlt086 - Event 4 Hog Floppy Drive Cable Problems

   EMBED

Share

Transcript

T E C H N I C A L Event4/HOG B U L L E T I N S H E E T Moving Light Consoles TBJLT086.doc Date: 11 March 2003 Floppy drive cable problems A number of users have reported problems with floppy disk drives not operating after transport. Internal inspection reveals the power and/or data cables have fallen out. The solution is to glue the power and data cables to the floppy disk drive using neutral cure silicone sealant. Note: silicone sealant that is not “neutral cure” releases a mild acid when it cures. This acid attacks the PCB copper, possibly causing a premature failure. Place a daub of silicone sealant on the locking tab of the power connector and on the locating tab of the data connector after the cable has been inserted. Leave the sealant to dry for 24 hours before movement Jands Electronics Pty Ltd/ 40 Kent Rd/ Mascot/ NSW/ 2020/ Australia Phone: +61 (2) 9582 0909 Fax: +61 (2) 9582 0999 Email: [email protected] Specifications subject to change without notice. Manufactured by Jands Electronics Pty Ltd ACN 001 187 837 Note: While all due care has been taken in the preparation of this document, Jands Electronics shall not be liable for any inaccuracies or omissions which may occur herein.