Transcript
Technical Data Sheet: MATERIAL:
ESPEJO PLATA (PS Mirror Silver/Gold FT 230)
REF: PSE FT 230 is a sheet of high impact polystyrene sheet laminated with metallised polyester film. The polyester film material describes 0,012 mm Very bright Silver and Coloured Polyester+ABS heatseal adhesive is optically clear, dyed where requested, and metallised on one side. The metallising is over coated with a heat-seal lacquer. CHARACTERISTICS Metal density Colour Coating weight Film yields Lacquer softening point Tensile strength Elongation Dimensional stability Shelf life
TEST METHOD Internal Internal Internal Internal Internal ASTM-D 882A 10 min at 100c Internal
TYPICAL VALUE 1,0-1,5 Ohm As standard AE 5,0 3,0-4,0 g/m2 19,9-20,9 g/m2 47,8-50,3 m2/kg 140-150c 21,0 Kgf/mm2 (machine dir) 130% (machine direction) 1,0% maximum 3 months from receipt when stored in conditions not exceeding 20c/50% RH
HIGH IMPACT POLYSTYRENE General Properties Density natural colour
DIN 53479
g/ccm
1,04
Vicat softening temperature
ISO 306/B50
°C
89
Thermal conductivity
DIN 52612
W/K*m
0,17
1/K
8-11*10"-5
DIN 53495
%
< 0,1
Tensile strength
DIN 53455
N/mm2
30
Percentage elongation at break
ISO 527-2/1N50
%
> 30
Flexural strength
DIN 53452
N/mm2
55
Modulus of elasticity
DIN 53 457
N/mm2
1950
Impact resistance Charpy 23°C
ISO 179/1 eU
kJ/m2
75
Impact resistance Charpy -40°C
ISO 179/1 eU
kJ/m2
50
Impact resistance Charpy 23°C
ISO 179/1 eA
kJ/m2
8
Impact resistance Izod 23°C
ISO 180/1 U
kJ/m2
85
Impact resistance Izod 23°C
ISO 180/1A
kJ/m2
10
Ball indentation hardness H 358/30
DIN 53456
N/mm2
95
Volume resistivity
DIN 53 482
Ohm*cm
> 10"14
Surface resistance
DIN 53482
Ohm
> 10"13
Coefficient of linear expansion Water absorption Mechanical Properties
Electrical Properties
13.04.1999 Information on the above characteristics is based on tests we believe to be reliable. These contain typical values that vary according to different conditions of use. The data are intended only as a source of information and are given without any warranty or liability by CADILLAC PLASTIC, S.A,. Purchasers should determine by themselves the convenience or not of these materials for their specific purposes or applications.
