Technical Support Hotline Tel: 01928 570555

Transcript

Return to M Series menu Print Menu Installation Instructions (Remote Key Models) SIREN KEYPAD (Standard or Battery Backup) Mount siren under bonnet away from direct sources of water and heat Mount Keypad on vehicle dash or inside the Glove box BONNET SWITCH Use a suitable bonnet switch for vehicle * # 1 2 3 4 5 6 7 8 9 0 ANTENNA Route antenna up "A" post. Keep the last 15 cm straight. Keep away from other vehicle wiring. Keep short antenna's as straight as possible, away from other wiring and where possible not shielded by metal work. L.E.D Mount L.E.D on visible area of dash **** Models supplied with a steel box **** K/P LED US/TX US/RX ECU must be secured in the steel box behind the vehicle dash. Secure with self tap security screws against a flat metal surface of the vehicle, remove padding where steel box will be mounted. KEEP AWAY from sources of water, heat and other vehicle electronic control devices (E.C U). SIREN 4 3 2 1 20 19 10 MAIN 18 17 16 15 14 13 12 ULTRASONIC Fix eyes securely to vehicle "A" posts pointing them towards the rear screen of the vehicle 11 1 ALARM ECU Conceal ECU in a secure area behind vehicle dash. Secure with self tap screws or tie wraps. KEEP AWAY from sources of water, heat and other vehicle electronic control devices (E.C.U). Negative Trigger 1 Connect to existing Courtesy light pinswitch circuit 1 Blue Violet Negative Trigger 2 Connect to vehicle boot switch and/or other triggers(s) 2 Blue/Red Violet Accessory Output Negative output when system is armed supply (200mA Max) 3 Green/Black Violet/White13 Immobiliser circuit 2 Accessory 2 Output Programmable negative output (200mA max) 4 Green/Red Violet/White14 Immobiliser circuit 2 Alarm negative supply 1 Connect to a good vehicle bodywork earth 5 Black Red/Yellow15 Hazard Supply Alarm negative supply 2 Connect to another good vehicle bodywork earth 6 Black Yellow Ignition +12V Supply Connect to+12 volt with vehicle ignition ON 7 Orange Yellow Alarm +12 volts supply Connect to a constant+12 volts Fused at 3 Amps 8 Red Green/Orange 18 Accessory 1 Output Central locking control See locking configuration diagram 9 Pink Green/White 19 Central locking control Central locking control See locking configuration diagram 10 Blue/White Pink/Black 11 Immobiliser circuit 1 Connect to vehicle circuit to immobilise...eg. Starter Solenoid 12 Immobiliser circuit 1 Connect to vehicle circuit to immobilise...eg. Starter Solenoid Connect to vehicle circuit to immobilise...eg. Fuel Pump Connect to vehicle circuit to immobilise...eg. Fuel Pump Connect to polarity required to feed hazards (fused at 15Amps) 16 Hazard output Connect to one side of vehicle hazard circuit 17 Hazard output Connect to other side of vehicle hazard circuit Negative output when alarm sounding (200mA max) See locking configuration diagram 20 Central locking control See locking configuration diagram TECHNICAL SUPPORT HOTLINE Tel: 01928 570555