Preview only show first 10 pages with watermark. For full document please download

/templatedata/automated/resource_documents_support/data/video/setup_maintenance/acs_powercam_presenter_setting_up_powercam_presenter

   EMBED

Share

Transcript

Setting up the Polycom PowerCam Presenter What's in the boxes? Setting up the Controller Note: If you are connecting an optional Polycom® VSX™ video conferencing system to your Polycom PowerCam Presenter™, see the other side of this document. Male RCA to female S-video adapter 10’ or 100’ camera cable Camera power cables A/C power cable 90-250VAC 50/60Hz 4A 1 1 1 Select Zoom In Preset 1 Auto Zoom 25’ S-video cable Preset 2 Presenter View Tight Wide Left Right Off 2 2 Video output from connector shows Presenter icons and messages Menu Zoom Out IOIOIO VCR/DVD VCR or DVD recorder LAN 8’ S-video cable LAN cable Use only for upgrading software Display Any video conferencing system Display Setting up the Locator Pack Assembly 1 2 Charging time: 3 hours Operating time: 8 hours 3 4 b Caution Refer to the User’s Guide for the Polycom PowerCam Presenter for important information about charging and using the battery pack. Attach the belt clip to the locator pack OR attach the lanyard to the locator pack. Setting up the Controller with a VSX Video Conferencing System Powering on the Polycom PowerCam Presenter S-video gender changer adapter 1 After all the cables are connected, power on the Polycom PowerCam Presenter controller: 2 If you have a VSX video conferencing system, power it on next: 3 Wait 90 seconds, and then power on the locator pack: 10’ or 100’ camera cable 10’ or 100’ camera cable Camera adapter cable Male RCA to female S-video adapter 1 1 VG A 2 Camera power cables 25’ S-video cable 90-250VAC 50/60Hz 4A IR 3 VCR/DVD PC CARD 2 IOIOIO 1 2 VG A LAN VSX video conferencing system 90-250VAC 50/60Hz 4A PowerCam Presenter Controller 1 1 1 IOIOIO 2 LAN 2 Video output from connector shows Presenter icons and messages LAN cable 8’ S-video cable A/C power cable Use only for upgrading software Display Setting up the Camera 1 2 3 4 Place the camera where it will be no more than 50 feet (15.2 meters) away from the person wearing the locator. Place the camera about 6 feet (1.8 meters) to 7 feet (2.1 meters) above the floor. Leave at least 1 foot (.3 meters) between the back of the camera and the wall. If you add acoustic foam on the wall, you can place the camera slightly closer than 1 foot (.3 meters) from the wall. 1725-23626-001/A ©2006, Polycom, Inc. All rights reserved. Polycom® and the Polycom logo are registered trademarks, and Polycom PowerCam Presenter™ and VSX™ are trademarks of Polycom, Inc.