Preview only show first 10 pages with watermark. For full document please download

Tentec Orion Modifications To The Rig Blaster Pro 4 Pin Microphone

   EMBED

Share

Transcript

TenTec Orion modifications to the Rig Blaster Pro 4 pin microphone cable and 4T8 adapter. On the 4 pin female mic connector end of the cable with the Rj45 on the other end, strip the Green/White wire and run underneath the connector shell. The Green/White wire within the cable ties to pin 6 on the jumper block thru the Rj45. This provides PTT Ground for the Orion microphone. RX AUDIO RX AUDIO MIC MIC MIC GRD 8 8 MIC GRD 7 7 GND TIE 6 6 GND TIE 5 5 PTT GND 4 4 PTT GND 3 3 PTT 2 2 PTT 1 1 CAT5 Mic cable - Rear side of jumper block Front panel 8 pin connector - Front side of jumper Within the 4T8, 4-to-8 pin adapter - on the 4 pin in-line male mic connector end, strip the Green/White wire and run underneath the connector shell. Connect the Green/White wire to pin 6 on the 8 pin female connector.