The Injector The Splitter Cable Length Monitor Poe

Transcript

MONITOR PoE Splitter and Injector Kit Part Number: POI-2002 POE-2002 Supply power to devices over an Ethernet Cable • Powers all Geist Climate Monitors over Ethernet cable connection • Saves wiring remote power supply • 300’ length • No software required • Simple PoE Injector: Weight 200g, 117 x 60 x 35mm. Combines 120VAC with data. Output is CAT5 cable up to 300’. Power cord included. Power over Ethernet eliminates the need to run 110/220VAC power to Geist Climate Monitors and other devices on a wired LAN. Installers only need to run a CAT5 cable that will carry both data and power to each device. The configuration is made up of two components: the injector takes data in from an Ethernet hub and power from a wall outlet and outputs both data and power through a CAT5 cable. The splitter is placed at the end of the CAT5 cable, returning data and power to their respective cables. The Injector The Level One 1-port Power over Ethernet injector takes a 100-240VAC signal with a maximum current draw of 0.3A. A straight-through CAT5 cable can be routed from a router or hub into the Data In port on the injector. Output is a -48VDC signal carried to the splitter via another CAT5 cable. The Splitter The Level One Power over Ethernet Splitter has the option of either outputting a 5VDC or 12VDC power signal from the -48VDC on the DATA IN port. Set 5V or 12V with the dip switch located on the side of the unit. The 12V setting powers a RSE-B, RSE2, or RSMini. PoE Splitter: Weight 150g, 80 x 55 x 26 mm. Separates power and data into ethernet cable and barrel plug. Set the DIP switch on the side to 12v to power your climate monitors. Climate Monitor To Internet Network PoE Cat-5 300’ Ethernet Power Cable Length PoE Splitter POS-2002 The specified maximum length of cable allowed between the injector and splitter should be 100 meters or approximately 300 feet. The signal will start to degrade past this length. PoE Injector POI-2002 120VAC Power Configuration for a Power over Ethernet system. Ethernet cable between the injector and splitter should be straight through and less than 100m. Please note the information contained herein is for informational purposes only. Technical claims listed depend on a series of technical assumptions. Your experience with these products may differ if you operate the products in an environment, which is different from the technical assumptions. Geist reserves the right to modify these specifications without prior notice. Geist makes no warranties, express or implied, on the information contained in this document. 10009001 Geist Americas 800.432.3219 geistglobal.com Geist Europe Geist DCiM 1.877.449.4150 +44 (0) 1823 275100 geistglobal.com geistglobal.com Geist Asia China +86.755.86639505 geistglobal.com Hong Kong +852 90361927 geistglobal.com