Transcript
Category: Installation & Configuration Note Sub-category: Integration Model: ACM-4xxx, TCM-4xxx Firmware: N/A Software: N/A Author: Corine.Hsu Published: 2009/11/26 Reviewed: 2009/12/09
ACTi Knowledge Base
Third Party Housing for Cube Camera Contents Introduction Third Party Indoor Housing: Videolarm ACEM20 Videolarm ACEM20 Specification Installation How to avoid Power LED Reflection Disclaimer
Introduction ACTi does not provide surface mount housing on our own. We suggest housings from a third party supplier (Videolarm), which can be another choice for our customers.
1
www.acti.com
Third Party Indoor Housing: Videolarm ACEM20
Provider
Videolarm
Type
Indoor Surface Mount Wedge housing
Camera Model
ACM-4xxx , and TCM-4xxx cube camera
Model
ACEM20CT , ACEM20CTH
Product sheet
Click here
Vendor
Videolarm
Advantage
Vandal-Resistant Housing
Certification
RoHS ,WEEE
Website
www.videolarm.com
Contact
[email protected]
2
www.acti.com
Videolarm ACEM20 Specification Customer can visit Videolarm website www.videolarm.com to find the more information. Body Construction
14-gauge steel
Viewing Window Construction
3/16" Polycarbonate
Environment
Indoor
Heater
No
Blower
No
Housing Type
Vandal Proof
Form Factor
Wedge
Mounting Style
Surface
RoHS
Yes
WEEE
Yes
Mechanical Specification Size (h*w*d)
4.67" x 5.44" x 9.15" (118.6mm x 138.2mm x 232.4mm)
Max camera length
8"
Weight
2.2 lbs/ 1 kg
Construction Body
14-gauge steel, off-white powder coast
Faceplate
3/16" polycarbonate with paint shield
Electrical Specifications Power Input
24 VAC, 50/60 Hz
Heater
24 VAC, 25 VA, 1.04 Amps
Architectural Drawing
3
www.acti.com
Installation Please follow the Instruction Guide from Videolarm to install the camera.
Pass the network cable and power cable through the access hole and then attach and tighten the camera.
Attach the housing top back to the housing using the screws.
4
www.acti.com
How to avoid Power LED Reflection The power LED can be used to find out what status the device is in right now. For instance, while booting up, upgrading firmware or when boot up failed. However, the power LED indicator may cause reflection if it is installed in the box housing.
User can cover the LED with sticker. Besides, if device is using our firmware version v.3.11.13 (ACM series) or v4.06.09 (TCM series) and later, we provide URL commands to disable the Power LED. Copy and paste the following lines into Internet explorer and press enter. You will need to enter device User Name and Password to execute this command. (Default: Admin/123456)
***Make sure to change the IP / Port to your actual camera settings! ***
Disable the Power LED: http://192.168.0.100:80/cgi-bin/cmd/system? &POWER_LED=0
Enable the Power LED: http://192.168.0.100:80/cgi-bin/cmd/system?POWER_LED=1
Read the current Power LED setting: http://192.168.0.100:80/cgi-bin/cmd/system?POWER_LED
Disclaimer ACTi will not guarantee temperature operation range in extreme weather conditions. ACTi can offer the test report from the third party housing and suggest our customer to purchase the housing by themselves.
5
www.acti.com
