Transcript
TK503 Programming Cable
Page 1 of 1
TK503 Programming Cable - PC-side: USB connector type A - AC500-side: SUB-D, 9-pin, male - Length 3 m Contents Intended Purpose Electrical Connection Technical Data Ordering Data
Intended Purpose The TK503 Programming Cable connects the USB interface of a PC with the serial interface of an AC500 CPU. It is used for programming purposes. The Programming Cable TK503 can be used with all AC500-CPUs. NOTE With AC500-CPUs, only the ABB programming cables TK50x can be used. Other cables may cause communication faults and must not be used. NOTE
Electrical Connection 1. Install the device driver for the TK503 Programming Cable. The driver and a detailed installation description can be found on PS501 CD in directory l
CD_AC500\Driver\TK503 (PS501 V1.3.x)
l
CD_AC500\Driver\TK503_TK504 (PS501 V2.0.0 and above)
NOTE
Once you have installed the device driver of the cable in your Windows system, make sure that you use always the same USB port of your computer. Otherwise, Windows will ask you to install the driver a second time if you connect the cable to a different USB port of your computer.
2. Plug the 9-pin Sub-D plug to the connector at the AC500-CPU and tighten it there. 3. Plug the USB connector to an USB interface at your PC.
Technical Data The System Data of AC500 and S500 are valid here. Only additional details are therefore documented below. Connector at the PC (USB interface)
USB connector type A
Connector at the AC500 CPU Length
SUB-D, 9-pin, male 3m
Cable type Weight
On Request On Request
Ordering Data Ordering No.
Scope of delivery
1TNE 968 901 R1100
TK503, Programming cable USB -> SUB-D (RS485), length 3 m
© Copyright 2005-2013 ABB. All rights reserved. Documentation Revision V2.3.2 Date of issue: 2014-02-14
mk:@MSITStore:C:\Program%20Files%20(x86)\3S%20Software\CoDeSys%20V2.3... 26-11-2014
