Transcript
TN-300 SPECIFICATIONS Turntable section Drive System
Belt Drive
Motor
DC Motor
Speed
33 1/3 RPM, 45 RPM
Rotation Speed Variation
+/–2%
Wow and Flutters
0.2%
Signal-to-Noise Ratio
67dB or higher (A-weighted, 20kHz LPF) 60dB or higher (unweighted, 20kHz LPF)
Platter
Aluminum Die-cast
Diameter of Platter
12", 30cm
Tonearm section Type
Static Balance, Straight
Effective Arm Length
8.8", 223mm
Stylus Pressure Range
0 to 5g
Supported Cartridge Weight
3.5 to 6.5g
Anti-skating Adjustment
Supported
Cartridge section Type
MM type (audio-technica AT95E factory installed)
Stylus Shape
Elliptical
Stylus Construction
Bonded Round Shank
Mount
Half inch
Frequency Response
20Hz to 20kHz
Channel Separation
20dB at 1kHz
Channel Balance
2.0dB
Tracking Force
1.5 to 2.5g
Vertical Tracking Angle
20 degrees
Supported Load Impedance
47k ohms
Output Voltage
4.5mV +/–3dB
Stylus Pressure
2.0g +/–0.5g
Cartridge Weight
5.7g +/–0.5g
Head-shell Weight
10g (including Screws, Nuts and Wires)
Replacement Stylus
audio-technica ATN95E
Phono Equalizer Amplifier Type of Amplifier
MM type (On/Thru switchable)
Analog Output Connector
RCA Pin jack (Gold-plated)
Output Voltage
Phono/Line switchable
Phono Output
4.5mV +/–3dB
Line Output
120mV (–13dBV)
USB Output section Connector
USB B type
Output Signal
PCM 48kHz/16-bit
Supported OS
Windows 7, Windows 8, Windows 8.1, OS X Lion(10.7), OS X Mountain Lion(10.8), OS X Mavericks(10.9)
Power
AC 100 to 240V, 50/60Hz
Power Consumption
1.5W (less than 0.5W at Standby)
Overall Dimensions (W x H x D)
16.5" x 4.6" x 14.0" 420 x 117 x 356 mm
Weight
Approx. 10.8 lbs. 4.9 kg
Accessories
Rubber Sheet, EP Adapter, Counter Weight, Head-shell (audio-technica AT95E), Platter, Dust Cover, Rubber Feet fro Dust Cover x2, Hinge x2, RCA Audio Cable, USB Cable, AC Adapter (GPE053A-120050-Z), Owner's Manual (including Warranty Card)
