Preview only show first 10 pages with watermark. For full document please download

To Program Mxp*oven Using A Standard Flash Drive:

   EMBED

Share

Transcript

To program MXP*oven using a standard flash drive: Oven must be in Off mode (Preheat must be OFF) 1. Remove protective cover from bottom of keypad. 2. Insert the flash drive into the slot located below the keypad. 3. From Off, press and hold the “2” pad to go to “User Options”. 4. Go to Option #17 by pressing “Back ” or repeatedly pressing “Enter ” 5. Select the desired operation by highlighting “Transfer flash drive to oven oven to flash drive ” with the Scroll Up or Scroll Down ” or “Transfer keypad. *Important Note: After inserting flash drive in USB port wait at least 15 seconds before proceeding to Step 6. 6. Press the “Program ” pad to begin the transfer (The screen will indicate”TRANSFERRING” and indicate “DONE” wait 60 seconds then transfer is complete.) *Important Note: It is crucitial to wait a full 60 seconds to assure data is transfered. If you do not wait 60 seconds when new upload is attempted the screen may indicate “ NOT AXP CARD” when uploading data to oven. 7. Remove flash drive and close the protective cover. Optional: If possible insert flash drive into PC USB drive and confirm the file is on the flash drive. You should see “AXP. ACP” or “MXP. ACP” for the file name. When removing flash drive from PC make sure to use the “Safely Remove Drive Utility”.