Transcript
vigilant ii coal stove
Traditional Warmth
Vermont Strong Enjoy the Warmth and Comfort of Coal For steady, low maintenance, high-output heat, nothing compares to a coal stove by Vermont Castings®. The Vigilant II cast iron coal burning stove can heat up to 2,000 square feet for up to 18 hours on a single load. There’s even an automatic thermostat to ensure steady heat flow to your home. Classic style and modern convenience – a Vermont Castings exclusive.
Features
Optional Accessories
• Whole house heater - up to 2,000 sq.ft.
• Automatic thermostat for steady heat
• Rear and bottom heat shields
• Clean and convenient top loading
• Durable cast iron construction
• Warming shelf (Classic Black)
• Special shaker grate system for easy
• Up to 18 hours on a single load of
• Outside air adapter
anthracite; 16 hours with bituminous
operation
• Stove surface thermometer
• Available in Classic Black
• Large swing-out ash pan with lid
• 8" oval flue collar
Technical specifications dimensions
Heating Capacity
Actual Size
30”W x 331⁄2”H x 23”D
Burn Time
Up to 18 hours on a single load of anthracite
Flue Size
6" round standard (8" oval available)
Approx. Heating Area
Approximately 2,000 sq. ft.
Fuel Capacity
45 lbs.
Maximum Heat Output
50,000 BTUs/hour
Coal Type and Size
Bituminous or Anthracite (Pea or Nut)
Vigilant ii (Model 2310) clearances Unprotected surfaces Parallel to Wall
protected surfaces
Stove in Corner
Parallel to Wall
Stove in Corner
Side
Rear
Corners
Side
Rear
Corners
Single-wall connector, no heat shields
18" (457 mm)
20" (508 mm)
16" (406 mm)
7" (178 mm)
13" (330 mm)
9" (229 mm)
Single-wall connector, top exit, rear and chimney connector heat shields1
18" (457 mm)
13" (330 mm)
16" (406 mm)
7" (178 mm)
11" (279 mm)
9" (229 mm)
Single-wall connector, rear exit, rear heat shield
18" (457 mm)
13" (330 mm)
N/A
7" (178 mm)
11" (279 mm)
N/A
Double-wall connector, top exit, rear heat shield
151⁄2" (394 mm)
13" (330 mm)
16" (406 mm)
7" (178 mm)
101⁄2" (267 mm)
9" (229 mm)
1 A ceiling heat shield, 24" (610 mm) in diameter and suspended 1" (25 mm) from the ceiling, must surround the chimney connector in installations in which the chimney connector penetrates the ceiling. The chimney connector shield extends only to 24" (610 mm) above the flue collar.
Your Vermont Castings Dealer
149 Cleveland Drive, Paris, Kentucky 40361 vermontcastings.com
HPBA
Hearth, Patio & Barbecue Association
made in U.S.A.
To avoid personal injury or property damage, the product described by this brochure must be installed, operated and maintained in strict compliance with the instructions packaged with the product and all applicable building or fire codes. Contact local building or fire officials about restrictions and installation inspection requirements. All photographs and drawings in this brochure are for illustrative purposes only and are not intended for, nor should they be used as a substitute for the instructions packaged with the unit. Appearance and specifications of the product are subject to change without notice. ©2014 Vermont Castings Group VC1508 v3
