Preview only show first 10 pages with watermark. For full document please download

Treadmills • Remove Motor Cover And Clean

   EMBED

Share

Transcript

Treadmills                   Remove motor cover and clean area Clean area beneath treadmill Inspect and test display Inspect and test stop switch Inspect and clean computer processor board and wire connectors Inspect frame, toe guards, and end caps Inspect and center striding belt Inspect deck Inspect wax bag, wax and nozzle pump (if applicable) Inspect and clean debris brush (if applicable) Check tension on drive belts Inspect front and rear rollers Inspect power cord and test outlet for proper grounding Level the machine Inspect and test lift motor Inspect and test speed controller Inspect and test heart rate sensors Inspect anti-static cord Bikes                 Inspect and remove housing Inspect and clean overlay Inspect drive belt for wear Test and adjust belt tension Lubricate drive chain Inspect crank arm and drive sprocket, adjust as needed Inspect pedals and pedal straps Inspect and lubricate seat post Inspect and clean alternator Test display monitor Inspect and clean battery terminals Test heart rate sensors Level the machine Examine and clean electrical connectors Test overall operation Inspect and clean pulley/freewheel gear and bearing assembly Cross – Trainer / Elliptical Trainer              Inspect and remove housing Inspect and clean overlay Inspect and clean drive system Inspect and clean alternator Clean printed circuit boards Examine and clean electrical connectors Inspect wire harness Inspect and lube bearings Inspect and adjust belt tension Test display monitor Test heart rate sensors Level the machine Test overall operation Stairclimber or Specialty Trainers             Inspect and remove housing Inspect and clean overlay Inspect and clean drive system Inspect and clean alternator Clean power board connectors Inspect wire harness Inspect and lube bearings Inspect and adjust belt tension Test display monitor Test heart rate sensors Level the machine Test overall operation Strength Stations              Inspect and lubricate liner bearing Inspect and clean upholstery Inspect cables for wear Inspect handgrips Inspect, clean, lube, all adjustable areas Inspect weight stack pin Set cables to proper tension Inspect pulleys for proper orientation Examine and lubricate all guide and linear rods Inspect all hardware for proper tension Examine bumpers Inspect and lube seat pins / adjustments Inspect and lubricate range limiter