Transcript
Optoway
TRSL-5380G
1
***********************************************************************************************************************************************************************
TRSL-5380G / TRSL-5380AG / TRSL-5380CG / TRSL-5380ACG 3.3V / 1550 nm / 622 Mbps RoHS Compliant SFF LC SINGLE-MODE TRANSCEIVER **********************************************************************************************************************************************************************
FEATURES
DESCRIPTION
l l l l l l l l l l l l l l
The TRSL-5380G series single mode transceivers is small form factor, low power, high performance module for bi-directional serial optical data communications such as SONET OC-12 LR-2 / SDH STM-4 (L-4.2) and Fiber Channel. This module is designed for single mode fiber and operates at a nominal wavelength of 1550 nm. A guaranteed minimum optical link budget of 26 dB is offered which can correspond to a link distance of over 80 km (assuming worst case fiber loss of 0.25 dB/km). The transmitter section uses a multiple quantum well 1550 nm DFB laser and is a class 1 laser compliant according to International Safety Standard IEC-60825. The receiver section uses an integrated InGaAs detector preamplifier (IDP) mounted in an optical header and a limiting post-amplifier IC. A PECL logic interface simplifies interface to external circuitry.
Duplex LC Single Mode Transceiver SONET OC-12 LR-2 / SDH STM-4 (L-4.2) Compliant Small Form Factor, RJ-45 size, 2X5 pin Package 1550 nm DFB LD Transmitter 26 dB Link Power Budget at Least LVPECL Signal Input / Output LVTTL Transmitter Disable Input LVPECL Signal Detect Output: TRSL-5380G LVTTL Signal Detect Output: TRSL-5380CG Single +3.3 V Power Supply 0 to 70oC Operating: TRSL-5380G -20 to 85oC Operating : TRSL-5380AG Wave Solderable and Aqueous Washable Class 1 Laser International Safety Standard IEC-60825 Compliant
LASER SAFETY
APPLICATIONS
This single mode transceiver is a Class 1 laser product. It complies with IEC-60825 and FDA 21 CFR 1040.10 and 1040.11. The transceiver must be operated within the specified temperature and voltage limits. The optical ports of the module shall be terminated with an optical connector or with a dust plug.
l ATM 622 Mbps Links l SONET/SDH Equipment Interconnect l Fiber Channel 533 Mb/s Links
ORDER INFORMATION P/No. TRSL-5380G TRSL-5380AG
Bit Rate (Mb/s) 622 622
SONET /SDH LR-2/L-4.2 LR-2/L-4.2
Distance (km) 80 80
Wavelength Package (nm) 1550 DFB 2X5 LC 1550 DFB 2X5 LC
RoHS Temp. TX Power RX Sens. (oC) (dBm) (dBm) Compliant 0 to 70 2 to -3 -29 Yes -20 to 85 2 to -3 -29 Yes
Absolute Maximum Ratings Parameter Storage Temperature Operating Temperature
Symbol Tstg Topr
Soldering Temperature Power Supply Voltage Input Voltage
--Vcc ---
Output Current
Iout
Min -40 0 -20
Units o C o C
0 GND
Max 85 70 85 260 4.5 Vcc
0
30
mA
Min 3.13 0 -20 50
Typ 3.3
Max 3.47 70 85
o
C V V
Notes TRSL-5380G TRSL-5380AG/air flow 1m/sec 10 seconds on leads only
Recommended Operating Conditions Parameter Power Supply Voltage Operating Temperature
Symbol Vcc Topr
Data Rate Power Supply Current
Icc
622 200
300
Units / Notes V o C / TRSL-5380G o C / TRSL-5380AG/air flow 1m/sec Mb/s mA
***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail:
[email protected] http: // www.optoway.com.tw
12/1/2005 V2.0
Optoway
TRSL-5380G
2
***********************************************************************************************************************************************************************
Transmitter Specifications (0 oC < Topr < 70 oC, 3.13V < Vcc < 3. 47V) Parameter Optical Optical Transmit Power Output Center Wavelength Output Spectrum Width Extinction Ratio Output Eye Optical Rise Time Optical Fall Time Relative Intensity Noise Total Jitter Electrical Data Input Current – Low Data Input Current – High Differential Input Voltage Data Input Voltage – Low Data Input Voltage -- High Disable Input Voltage -- Low Disable Input Voltage -- High Shut Off Time for TxDis
Symbol
Min
Typ
Max
Units
Po -3 --2 dBm 1480 1580 nm λ ----1 nm ∆λ ER 10 ----dB Compliant with Bellcore GR-253-CORE and ITU recommendation G.957 tr 1.2 ns tf 1.2 ns RIN -120 dB/Hz TJ 0.55 ns IIL IIH VIH - VIL V IL - VCC V IH - VCC VTDIS,L VTDIS,H tDIS
-350 350 300 -2.0 -1.1 0 Vcc – 1.3
-1.58 -0.74 0.5 Vcc 1
µA µA mV V V V V ms
Notes 1 -20 dB Width
10% to 90% Values 10% to 90% Values 2
3 3 TX Output Enabled TX Ouput Disabled
Notes: 1. Output power is power coupled into a 9/125 µm single mode fiber. 2. Measured with a 223-1 PRBS with 72 ones and 72 zeros. 3. These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs.
Receiver Specifications (0oC < Topr < 70oC, 3.13V < Vcc < 3.47V) Parameter Optical Sensitivity Maximum Input Power Signal Detect -- Asserted Signal Detect -- Deasserted Signal detect -- Hysteresis Wavelength of Operation Electrical Data Output Voltage – Low Data Output Voltage – High Signal Detect Output Voltage -- Low Signal Detect Output Voltage -- High Signal Detect Output Voltage -- Low Signal Detect Output Voltage -- High
Symbol
Min
Typ
Max
Units
Notes
--Pin Pa Pd
---5 ---40 1.0 1100
---
-29 ---29 ---
dBm dBm dBm dBm dB nm
1
V OL - VCC V OH - VCC V OL - VCC V OH - VCC VOL VOH
-2.0 -1.1 -2.0 -1.1 2.0
---------
1600 -1.58 -0.74 -1.58 -0.74 0.5
V V V V V V
Transition: low to high Transition: high to low
2 2 TRSL-5380G TRSL-5380CG
Notes: 1. Minimum sensitivity and saturation levels at BER=1E-10 for a 223-1 PRBS with 72 ones and 72 zeros. 2. These outputs are compatible with 10K, 10KH and 100K ECL and PECL outputs.
***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail:
[email protected] http: // www.optoway.com.tw
12/1/2005 V2.0
Optoway
TRSL-5380G
3
***********************************************************************************************************************************************************************
CONNECTION DIAGRAM
PIN 1 2 3 4 5 6 7 8
Symbol VEEr VCC r SD RD− RD+ VCC t VEEt TDis
9 10 MS
TD+ TDMS
Notes Directly connect this pin to the receiver ground plane +3.3V dc power for the receiver section Active high on this indicates a received optical signal. Receiver Dataout Bar. See recommended circuit schematic Receiver Dataout. See recommended circuit schematic +3.3V dc power for the transmitter section Directly connect this plan to the transmitter ground plane Transmitter Disable. Connect this pin to +3.3V TTL logic “1” to disable module To enable module connect to TTL logic low “0” Transmitter Data In. See recommended circuit schematic Transmitter Data In Bar. See recommended circuit schematic Mounting Studs. Connect to Chassis Ground
RECOMMENDED CIRCUIT SCHEMATIC Vcc3.3V
MICROSTRIP1
TD-
Z=50R MICROSTRIP2
LVPECL TD+
Z=5OR 150ohm
150ohm
TDTD+ TDis Veet Vcct
10 9 8 7 6
TDis(LVTTL)
Vcc3.3V
1uH
10nF
10nF 10uF
10uF 1uH
PHY DEVICE
Veer Vccr SD RDRD+
Vcc3.3V Vcc3.3V
130R
1 2 3 4 5
SFF2X5
10nF
Vcc3.3V
10uF RD+
MICROSTRIP3 Z=50R MICROSTRIP4
82R
LVPECL
130R RD-
Z=5OR SD
1K
TO LVPECL STAGE 82R
Note: 1. 1000ΩSD Output pull-down resistor required for TRSL-5120G / TRSL-5120AG (LVPECL SD Output) 2. No pull-down resistor required for TRSL-5120CG / TRSL-5120ACG (LVTTL SD Output) 3. Veer and Veet are not internally connected to each other. 4. 50 Ω line pattern and component placements on TD+/TD- and RD+/RD- lines shall be symmetrical for better impedance matching. ***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail:
[email protected] http: // www.optoway.com.tw
12/1/2005 V2.0
Optoway
TRSL-5380G
4
***********************************************************************************************************************************************************************
PACKAGE DIAGRAM Units in mm
1) Standard Case
TRSL-5380G / TRSL-5380AG / TRSL-5380CG / TRSL-5380ACG 2) Extended Case
TRSL-5380EG / TRSL-5380AEG / TRSL-5380CEG / TRSL-5380ACEG Note: Specifications subject to change without notice.
***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail:
[email protected] http: // www.optoway.com.tw
12/1/2005 V2.0
