Transcript
OPERATION MANUAL UFH-DDAEX Digital Distribution Amplifier 1st Edition
Precautions Important Safety Warnings [Power]
Stop
Do not place or drop heavy or sharp-edged objects on power cord. A damaged cord can cause fire or electrical shock hazards. Regularly check power cord for excessive wear or damage to avoid possible fire / electrical hazards.
[Circuitry Access]
Stop
Do not touch any parts / circuitry with a high heat factor. Capacitors can retain enough electric charge to cause mild to serious shock, even after power is disconnected. Capacitors associated with the power supply are especially hazardous. Avoid contact with any capacitors.
Hazard
Unit should not be operated or stored with cover, panels, and / or casing removed. Operating unit with circuitry exposed could result in electric shock / fire hazards or unit malfunction.
[Potential Hazards]
Caution
If abnormal smells or noises are noticed coming from the unit, turn power off immediately and disconnect power cord to avoid potentially hazardous conditions. If problems similar to above occur, contact authorized service representative before attempting to again operate unit.
[Consumables]
Caution
The consumables used in unit must be replaced periodically. For further details on which parts are consumables and when they should be replaced, refer to the specifications at the end of the Operation Manual. Since the service life of the consumables varies greatly depending on the environment in which they are used, they should be replaced at an early date. For details on replacing the consumables, contact your dealer.
Upon Receipt Unpacking UFH-DDAEX modules and their accessories are fully inspected and adjusted prior to shipment. Operation can be performed immediately upon completing all required connections and operational settings. Check your received items against the packing lists below. ITEM UFH-DDAEX Studs Screws Operation Manual
QTY 1 3 6 1
REMARKS For connecting UFH-70DDA For connecting UFH-70DDA
Check Check to ensure no damage has occurred during shipment. If damage has occurred, or items are missing, inform your supplier immediately.
Table of Contents 1. Prior to Starting ........................................................................................................................... 1 1-1. Welcome ............................................................................................................................. 1 1-2. Features .............................................................................................................................. 1 1-3. About This Manual .............................................................................................................. 1 2. Panel Descriptions ...................................................................................................................... 2 3. Connection .................................................................................................................................. 2 4. Operations .................................................................................................................................. 3 4-1. Power On ............................................................................................................................ 3 4-2. Video Input Setting.............................................................................................................. 3 5. Specifications and Dimensions ................................................................................................... 4 5-1. Unit Specifications............................................................................................................... 4 5-2. External Dimensions ........................................................................................................... 5
1. Prior to Starting 1-1. Welcome Congratulations! By purchasing UFH-DDAEX Digital Distribution Amplifier you have entered the world of FOR-A and its many innovative products. Thank you for your patronage and we hope you will turn to FOR-A products again and again to satisfy your video and audio needs. FOR-A provides a wide range of products, from basic support units to complex system controllers, which have been increasingly joined by products for computer video based systems. Whatever your needs, talk to your FOR-A representative. We will do our best to be of continuing service to you.
1-2. Features The UFH-DDAEX is an optional video distributor for UFH-70DDA. It can be installed in the UFH-108A or UFH-112A system frame. By connecting to the UFH-70DDA rear module, it can distribute two systems of one input into seven outputs. Supports HD SDI and SD SDI (auto-detection). Automatic cable compensation function for up to SD SDI 200m (using 5C-2V cable) and HD SDI 100m (using 5C-FB cable). Re-clock function. Input signal auto-recognition and detection of HD SDI and SD SDI. Supports DVB-ASI by changing the internal setting.
1-3. About This Manual This manual is intended to help the user easily operate this product and make full use of its functions during operations. Before connecting or operating your unit, read this operation manual thoroughly to ensure you understand the product. After reading, it is important to keep this manual in a safe place and available for reference.
1
2. Panel Descriptions HD/SD
HD/SD 1
HD/SD 2
HD/SD 3
HD/SD 4
VIDEO IN
VIDEO OUT
(1)
No. (1)
Name VIDEO IN
(2)
VIDEO OUT
HD/SD 5
HD/SD 6
HD/SD 7
UFH-70DDA
(2)
Description For HD-SDI/SD-SDI video input signal connection. For HD-SDI/SD-SDI video output signal connection. Distributes one signal input into seven outputs.
3. Connection The figure below shows how to connect UFH-DDAEX to other devices. Note that before installing the UFH-DDAEX module into the UFH-108A or UFH-112A system frame, you should thoroughly read the operation manual for the system frame. HD SDI signal or SD SDI signal
UFH-112A HD/SD SDI IN
HD/SD OUT 1 HD/SD OUT 2
UFH-DDAEX
HD/SD OUT 3 HD/SD OUT 4 HD/SD OUT 5 HD/SD OUT 6 HD/SD OUT 7
2
HD SDI signal or SD SDI signal
4. Operations 4-1. Power On 1) Loosen the two knob screws on the front panel face of the system frame, and then grasp the knob screws to pull them out. POWER 1
GENLOCK 1 2
FAN
ALARM TEMP DC POW
UFH-112
SYSTEM FRAME
POWER 2
GENLOCK 1 2
FAN
ALARM TEMP DC POW
2) Turn the power switch(es) ON.
4-2. Video Input Setting The I/O signal setting can be set to SD-SDI/HD-SDI or DVB-ASI by changing the switch on the rear module. The switch setting must be made prior to installing UFH-DDAEX to the UFH-108A/UFH-112A system frame. The factory default setting is VIDEO. To input a DVB-ASI signal, be sure to change the setting to DVB. Otherwise, the signal is not output properly. If the setting is changed to DVB, the DVB-ASI indicator on the front panel lights up.
ＵＦＨ-ＤＤＡEX rear module
VIDEO DVB
Switch Setting VIDEO position DVB position
3
Signal SD-SDI, HD-SDI DVB-ASI
5. Specifications and Dimensions 5-1. Unit Specifications Video Input Video Output Cable Compensation
Temperature Humidity Power Consumption Weight Dimensions Required Slot
HD-SDI: 1.485/1.001Gbps, SD-SDI: 143Mbps to 270Mbps, DVB-ASI: 270Mbps, 75Ω, BNC, 1 input HD-SDI: 1.485/1.001Gbps, SD-SDI: 143Mbps to 270Mbps, DVB-ASI: 270Mbps, 75Ω, BNC, 7 outputs Automatic cable compensation HD-SDI: 100m max. (5C-FB) SD-SDI: 200m max. (5C-2V) 10°C – 40°C 30% – 90% (no condensation) Supply from UFH Frame, +24VDC 3.8VA (3.8W) 0.3 kg Rear module: 141 (W) x 101 (D) mm 1 slot
4
5-2. External Dimensions (All dimensions in mm.) 141
VIDEO IN
U FH -7 0D D A
VIDEO OUT
20
HD/S D
(101)
HD/S D 1
HD/SD 2
HD/SD 3
HD/S D 4
HD/SD 5
HD/SD 6
HD/SD 7
87.8
UFH-70DDA (Reference drawing)
EXTENTION CARD(Option)
－－－－－－－－－－－－－
－－－－－－－－－－－－－－－－－－－－－－－－－－
A IN PU T
HD
B (OPTION) DV B-ASI
INPU T
HD
DV B-ASI
( OP TION) IN TE RFAC E UFH- 70DD A
5
(400)
379.5
I/F CARD (Option) POWER
UF H-70 DDA
Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.
05/16/2011 Printed in Japan
FOR-A COMPANY LIMITED Head Office Overseas Division Japan Branch Offices R&D/Production
3-8-1 Ebisu, Shibuya-ku, Tokyo 150-0013, Japan Phone: +81(0)3-3446-3936, Fax: +81(0)3-3446-1470 Osaka/Okinawa/Fukuoka/Hiroshima/Nagoya/Sendai/Sapporo Sakura Center/Sapporo Center
FOR-A America Corporate Office 11155 Knott Ave., Suite G&H, Cypress, CA 90630, USA Phone: +1-714-894-3311 Fax: +1-714-894-5399
FOR-A America East Coast Office 2 Executive Drive, Suite 670, Fort Lee Executive Park, Fort Lee, NJ 07024, USA Phone: +1-201-944-1120 Fax : +1-201-944-1132
FOR-A America Distribution & Service Center 2400 N.E. Waldo Road, Gainesville, FL 32609, USA Phone: +1-352-371-1505 Fax: +1-352-378-5320
FOR-A Corporation of Canada 346A Queen Street West, Toronto, Ontario M5V 2A2, Canada Phone: +1-416-977-0343 Fax: +1-416-977-0657
FOR-A Latin America & the Caribbean 5200 Blue Lagoon Drive, Suite 760, Miami, FL 33126, USA Phone: +1-305-931-1700 Fax: +1-305-264-7890
FOR-A UK Limited UNIT C71, Barwell Business Park, Leatherhead Road, Chessington Surrey, KT9 2NY, UK Phone: +44(0)20-8391-7979 Fax: +44(0)20-8391-7978
FOR-A Italia S.r.l. Via Volturno 37, 20047 Brugherio MB, Italy Phone: +39-039-881-086/103 Fax: +39-039-878-140
FOR-A Corporation of Korea 801 Dangsan Bldg., 53-1 Dangsan-Dong, Youngdeungpo-Gu, Seoul 150-800, Korea Phone: +82(0)2-2637-0761 Fax: +82(0)2-2637-0760
FOR-A China Limited 708B Huateng Bldg., No. 302, 3 District, Jinsong, Chaoyang, Beijing 100021, China Phone: +86(0)10-8721-6023 Fax: +86(0)10-8721-6033
*The contents of this manual are subject to change without notice.
