Transcript
1-Port Serial (RS-232) PCIe Host Card
User Manual Model: UGT-PCE10SR
All brand names and trademarks are properties of their respective owners
www.vantecusa.com
Contents Features and Benefits............................................................. 3 System Requirements ............................................................ 3 Package Contents................................................................... 3 Hardware Installation ............................................................ 3 Driver Installation .................................................................. 4
UGT-PCE10SR
Page 2
Features and Benefits
Compliant with PCI Express Specification 1.1 Supports x1, x4, x8, x16 PCI Express Bus Support 1 x UART serial ports Built-in 16C950 compatible UART 128-byte FIFO for transmit/receive Data transfer rate up to 230400bps Plug-n-Play, I/O address and IRQ assigned by BIOS Support Windows XP/Vista/7/8
System Requirements
Windows XP/Vista/7/8 (32/64 bit) One available PCI Express slot
Package Contents
1 x 1-Port Serial (RS232) PCIe Host Card 1 x Driver CD 1 x User Manual 1 x Low Profile Bracket
Hardware Installation 1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer’s cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the card, carefully align the card’s bus connector with
UGT-PCE10SR
Page 3
the selected PCIe slot on the motherboard. Push the board down firmly. 5.
Replace the slot bracket’s holding screw to secure the card.
6.
Secure the computer cover and reconnect the power cord.
Driver Installation 1.
Place the Driver CD into the CD-ROM drive. Click the Start button on the taskbar and click Run. Type “D:\UGT-PCE10SR\ Windows\Setup.exe”. (Assuming you have placed the CD in CD-ROM drive labeled as D).
2.
Follow any on-screen instructions to complete the software installation.
3.
Restart your system.
4.
Once you have rebooted the computer, this 1-Port Serial (RS232) PCIe Host Card is ready to be used.
UGT-PCE10SR
Page 4