Preview only show first 10 pages with watermark. For full document please download

Ui-3862le-c (ab00862) Specification Sensor

   EMBED

Share

Transcript

UI-3862LE-C (AB00862) Specification Sensor Sensor type Shutter Sensor characteristic Readout mode Pixel Class Resolution Resolution (h x v) Aspect ratio ADC Color depth (camera) Optical sensor class Optical Size Optical sensor diagonal Pixel size Manufacturer Sensor Model Gain (master/RGB) AOI horizontal AOI vertical AOI image width / step width AOI image height / step width AOI position grid (horizontal/vertical) Binning horizontal Binning vertical Binning method Binning factor Subsampling horizontal Subsampling vertical Subsampling method Subsampling factor CMOS Color Rolling shutter Linear Progressive scan 2 MP 2.12 Mpix 1936 x 1096 Pixel 16:9 12 bit 12 bit 1/2.8" 5.610 mm x 3.175 mm 6.45 mm (1/2.48") 2.9 µm Sony IMX290LQR-C 20x/5x same frame rate increased frame rate 32 / 8 2/2 4/2 - Subject to technical modifications (2017-10-22) Page 1 of 2 www.ids-imaging.com IDS Imaging Development Systems GmbH Dimbacher Str. 6 - 8 · 74182 Obersulm · Germany · Phone +49 7134 96196-0 · Fax +49 7134 96196-99 · E-mail [email protected] UI-3862LE-C (AB00862) Model Pixel clock range Frame rate freerun mode Frame rate trigger (continuous) Frame rate trigger (maximum) Exposure time (minimum - maximum) Long exposure (maximum) Power consumption Special features 20 MHz - 474 MHz 135 67 67 0.011 ms - 999 ms 120000 ms 0.9 W - 1.5 W Sensor source gain Ambient conditions The temperature values given below refer to the outer device temperature of the camera housing. Device temperature during operation Device temperature during storage Humidity (relative, non-condensing) 0 °C - 55 °C / 32 °F - 131 °F -20 °C - 60 °C / -4 °F - 140 °F 20 % - 80 % Connectors Interface connector I/O connector Power supply USB Type-C 10-pin Molex connector (IllumiMate) USB cable Pin assignment I/O connector 1 2 3 4 5 6 7 8 9 10 Voltage output (USB Power Delivery), 5-15 V Ground (GND) General Purpose I/O (GPIO) 2, 3.3 V General Purpose I/O (GPIO) 1, 3.3 V TWI (Two Wire Interface) clock signal TWI (Two Wire Interface) data signal Trigger input without optocoupler 3.3 V Flash output without optocoupler 3.3 V Ground (GND) Voltage output 3.3 V Camera rear view Design Lens Mount IP code Dimensions H/W/L Mass 36.0 mm x 36.0 mm x 8.6 mm 8.5 g Subject to technical modifications (2017-10-22) Page 2 of 2 www.ids-imaging.com IDS Imaging Development Systems GmbH Dimbacher Str. 6 - 8 · 74182 Obersulm · Germany · Phone +49 7134 96196-0 · Fax +49 7134 96196-99 · E-mail [email protected]