Transcript
UMD-606N 11n Micro Dongle User Guide
Index 1.
2.
Product Overview.................................................................................................................. 3 1.1.
Introduction................................................................................................................3
1.2.
Product Appearance.................................................................................................3
Installation.............................................................................................................................. 4 2.1.
3.
4.
Installing the Software of the Micro USB adapter.............................................. 4
Connect to Internet- Station Mode..................................................................................... 7 3.1.
Setup in Wireless Utility.......................................................................................... 7
3.2.
Setup Wireless LAN with WPS PBC...................................................................... 9
3.3.
Setup Wireless LAN with WPS PIN......................................................................10
Connect to WiFi Devices- AP Mode................................................................................. 12
Troubleshooting...........................................................................................................................14
Solwise Ltd
Page 3
UMD-606N
1. Product Overview 1.1. Introduction The UMD-606N Micro 802.11n USB Adapter is, in our opinion, the world’s smallest wireless adapter which provides a simple (physical WPS button) and secure (64/128bit WEP, WPA, WPA2 WLAN security) way to enable 150M 802.1n wireless access to your notebook or desktop computer. It uses the latest Green WLAN technology, which controls power consumption automatically in accordance with WLAN activities. No setting is required for this function. This Micro USB Adapter can save up to 80% power consumption compared with legacy 802.11n products.
1.2. Product Appearance
LED
Status
Description
On
Wireless USB dongle is powered on.
Off
Wireless USB dongle is powered off.
LINK/ACT
Solwise Ltd
Page 4
UMD-606N
2. Installation Describes the procedure for installing the UMD-606N.
2.1. Installing the Software of the Micro USB adapter (1). Don’t insert the Micro-dongle yet. First of all insert the product CD in to your PC. The CD should auto-run. At the welcome screen, please click Driver to install the driver and utility. If you don’t see the welcome screen, go to Start My Computer and click to open CD-ROM drive. Then double click autorun.exe and wait for few seconds, the welcome screen will show up.
Click “Next”.
Click “Install” to start the setup program.
Solwise Ltd
Page 5
UMD-606N
Waiting for system running. (2). Restart your computer Once the installation is finished, click Finish to restart you computer.
(3). Connect the USB Adapter Now plug the Micro Adapter into USB adapter on your Laptop or Desktop computer.
(4). Check the Wireless Connection Double click on Wireless Utility icon in the system tray or on the desktop.
Icon in System Tray
Utility icon on Desktop
Solwise Ltd
Page 6
UMD-606N
Click on the Available Network tab to view all the access points with the range of this adapter. Double click on the SSID that you want to connect.
If the wireless network you selected requires security, the utility will guide through the appropriate security setup.
After the signal strength is indicated, you have successfully set up your wireless network on you PC or Laptop.
Solwise Ltd
Page 7
UMD-606N
3. Connect to Internet-Station Mode Used as client to connect to an access point such as wireless LAN router.
The UMD-606N has 3 setup methods.
3.1. Setup in Wireless Utility Below illustrates how to select and connect to an access point through the installed Wireless Utility. (1). Check your wireless LAN setting information. Check the access point setting information and take note as list below. Name
Information set in the wireless router/access point
SSID
(Connection name)
Encryption type
Authentication type
WEP
Open System / Share Key / Auto
WPA /WPA2/
AES / TKIP
WPA2 Mixed Network key
(the Encryption key of the access point)
(2). Select Access Point
Solwise Ltd
Page 8
UMD-606N
Make sure the Micro Adapter is under “Station Mode”.
Click on Available Network tab to find the access points and double click on its SSID. If the access point you are connecting is not in the list, click “Refresh” to renew the list.
The Security setting window will show up if the access point requires security. Enter the information you checked from the access point and click “OK”.
Solwise Ltd
Page 9
UMD-606N
You can check General information once the wireless network connected successfully.
3.2. Setup Wireless LAN with WPS PBC If your wireless router /access point is WPS supported, you can make the connection by just pressing the WPS button.
Press the WPS button on your wireless router/ access point to enable the WPS paring.
Then release the button when
the WPS LED is lit.
Then you need press the WPS button on the Micro adapter. (If you can not press WPS button with your
fingers,
please press
it
with
something sharp, e.g. a pen). When the setup window shows up, releasing the button.
Solwise Ltd
Page 10
UMD-606N
You can check General information once the WPS connection is established.
3.3. Setup Wireless LAN with WPS PIN Setup the wireless LAN with a PIN code if the wireless router /access point supports WPS PIN function.
Open the Wireless Utility of Micro adapter and click the Wi-Fi Protect Setup. Write down the PIN code and press the
“Pin Input Config
(PIN)”.
Select a specific access point by click Yes.
Solwise Ltd
Page 11
UMD-606N
Click on the SSID which you want to connect. If the access point you are connecting is not in the list, click “Refresh” to renew the list
The Micro Adapter is waiting for the
connection
with
your
selected Access Point.
Meanwhile, open the Access Point’s setup page and input the PIN code.
You
can
check
General
information once the connection is established.
Solwise Ltd
Page 12
UMD-606N
4. Connect to WiFi Devices- AP Mode Use the UMD-606N as a wireless access point, and you can create direct WiFi links with other WiFi supported devices such as gaming machines or a mobile phone.
(1). Switch the Mode type to Access Point Select Access Point mode and wait for the system changed.
Solwise Ltd
Page 13
UMD-606N
Select the Internet connection you want to share and the Wi-Fi security setting to use for access point will be displayed.
Using you WiFi device to search for WiFi Connection. WiFi Networks.
You can find the AP in the
Solwise Ltd
Page 14
UMD-606N
Troubleshooting Problem
Corrective Action Make sure you have turned on your computer
None of the LEDs turn on when I plug in the wireless USB adapter.
Check the utility and driver for your WLAN adapter have installed correctly. Restart your computer and plug in the adapter again. Make sure there is no hardware conflict and check your computer resource information.
Cannot access the configuration utility.
Make sure the WLAN adapter is installed / plugged in properly. Check the utility version you have installed is correct. Make sure the ACT LED on the WLAN adapter is blinking. Check the wireless router is within range and move your computer closer to the wireless router.
I cannot connect to a
Make sure that you have set the wireless network settings
wireless network
correctly. For example, the SSID and security settings. Make sure there is no radio interference (for example, cordless phones, microwave oven, etc) that may affect wireless transmission quality.
European Union Statement of Compliance It is hereby declared that this wireless dongle is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
