Transcript
Cables, Connectors, and Panels General -- Wiring General -- Professional cable assemblies Cable - Cat5e UTP Cable - Cat5e STP for AV Cable - Cat6
Plenum rated cable for all installed AV systems Neoprene jacketing Belden, Comscope Crestron DM Ultra where connecting to Crestron equipment. Extron where connecting to Extron equipment. Belden. Belden, Comscope, Systemax
Connectors & Termination panels, Cat6 Connectors. Coaxial RF cable.
Hubbel, Comscope, Belden Compression Fittings. Extron & Belden (RG6 & RG59 type)
HDMI -- Factory made HDMI -- Fiber Extended
Extron, C2G Pro-series No Brand Preference. Submit for approval per job. No Brand Preference. Submit for approval per job if longer than 2 meters. No Brand Preference. Submit for approval per job Extron, Display manufacturer's recommended model, or CTG Professional models Extron. Extron. Extron or Belden (including WestPenn).
DVI -- Factory made DVI -- Fiber Extended Display Port -- Factory made VGA -- Factory Made user cables VGA -- Factory Made installation cables Microphone Cabling -- installed Microphone Cabling -- Flexible user cable assemblies.
Extron or Belden (including WestPenn). Neoprene jacketing
Speaker Wire line-level shielded TP hook-up cable. control wiring
Extron, Belden (including WestPenn), Liberty W&C Extron, Belden, Liberty W&C Crestron, Extron, Belden, Liberty W&C
Cable Labels
Pre-printed wrap-around.
Raceway - Surface. over-floor. ADA compliant
Legrand / Wiremold OFR series
Raceway - Surface. Wall/Ceiling, non-metallic. Low-voltage only
Legrand / Wiremold Uniduct, and 400 / 800 / 2300
User removable cables (from user computer or mic to jack) exempted. For mobile equipment and removable user cables. Use fully shielded connector with full circumference shield contact at cable. Installed per manufacturer procedures. Using manufacturer specified tools. Other high quality compression-fit systems with approval. 26Ga or thicker conductors required for total signal length exceeding 2 meters. Submit for UMSH AV Team Approval 26Ga or thicker conductors required if longer than 2 meters. Always check if DVI-I or Dual-Link are needed. Submit for UMSH AV Team Approval
Select 100% shielding. 26Ga or better. Select 100% shielding. 26Ga or better. Stranded or braided only, no solid code. Calculate attenuation when specifying length and load. Select models that include drain wire. For serial, IR, and other low data rate uses. Label both ends of installed cables with cable number and signal name. For rooms where coring is unavailable or impractical. May carry AC power with appropriate termination boxes. Mount using anchors & fasteners or 3M DualLock removable system. No loop & pile removable fasteners Use Wiremold specific fittings for all transitions and terminations. Mount using anchors & fasteners or 3M DualLock removable system. No loop & pile removable fasteners
