Transcript
Step 2: Antenna
A. Run antenna up through the dash to the bottom of the driver’s side windshield.
B. Clean surface thoroughly with provided wipe before attaching the antenna to the windshield surface.
C. Remove adhesive backing on the antenna and press firmly to windshield.
Unit 3 Models
Activation Hotline
(Supports Engine Data)
866.312.3782
24/7
83402, 83412
Step 3: IFTA Indicator
Step 1: Power Cable
(Optional Accessory — Proceed to Step 4 if Not Installing)
A. Locate the factory diagnostic port. Disconnect port
A. Locate a spot in the truck where the LED light will be
B. Connect the male end of the Deutsch pass-through
B. Use enclosed mounting bracket to adhere the light to
from dash.
cable to the diagnostic port.
visible to the driver.
the mounting location.
C. Install the female end in the original factory port location. C. Connect IFTA cable harness to tracking device. D. Make sure male end of the power cable is securely D. Connect up the RED wire from the IFTA light to the attached to the factory diagnostic port location. NOTE: After cable is attached, be sure to twist locking ring on power cable until it snaps in place. Factory screw holes may not match up to female end of power cable. A Universal Locking Ring has been provided to secure it to the factory port location if needed.
Da.
Db.
RED pigtail wire on the IFTA cable harness.
E. Connect up the BLACK wire from the IFTA light to the F.
BLACK pigtail wire on the IFTA cable harness.
When power is supplied in Step 4, LED indicator will illuminate, verifying proper installation of IFTA light.
Step 4: Tracking Device
A.
Attach antenna cables to tracking device. IMPORTANT: Be sure antenna cables are securely tightened to tracking device.
Aa.
Ab.
B.
D.
B. Attach power cable to tracking device. C. Gently tighten thumb screws where the
power cable connects to the tracking device. If not tightened properly, power cable will NOT be connected.
D. Verify power has been supplied by watching for green, E. F.
red and orange LED’s to illuminate and start flashing.
Watch for IFTA LED light to illuminate if installed. Installation supplies included: Velcro and/or tie wrap to secure device at install. IMPORTANT: Clean surface thoroughly with provided wipe before attaching tracking device if using Velcro.
G. Make sure tracking device is well hidden under dash to avoid tampering.
H. Secure any hanging wires into the dash. I. Before completing the installation (putting dash
back together), let truck idle for 5 minutes and call activation hotline to verify the location of the vehicle. Have the CyntrX Unit ID number available before calling 866-312-3782.
