Preview only show first 10 pages with watermark. For full document please download

Universal Power Cables To 4 Stud Busbar Installation

   EMBED

Share

Transcript

UNIVERSAL POWER CABLES TO 4 STUD BUSBAR Installation Guide Thank you for purchasing XTC's UNI-PWR-UP Power Cable Kit. The kit comes complete with everything needed for installation. The kit includes 8 Gauge power wires with a 50 Amp Circuit breaker for overall circuit protection and a 4 stud Busbar . More installation information can be found at www.xtcinstall.com Please read the instructions fully and familiarize yourself with the components before starting the install.  Before starting remove the ground wire from the battery.  Mount the Busbar on the firewall using the supplied #10 truss head screws  Run the power cable harness from the busbar on the fire wall to the battery.  Attach the red cable to the included circuit breaker  Using the self tapping screws attach the circuit breaker next to the battery  Attach the short red cable from the Circuit Breaker to the positive post on the battery  Attach any devices you would like to power to the Busbar using #10 ring terminals  Attach the black cable to the negative side of the battery along with reattaching the main cable.  Using the supplied cable ties coil up any cable not used and secure the cable away from any hot or moving parts. NOTE: Included in this kit is a #8 x 10 Ring connector and a #8 x 5/16 Ring connector with shrink, if desired the two cables can be cut shorter and these rings can be installed to make a custom length. More information on installation may be seen at www.xtcinstall.com. For support on installation we can be emailed at [email protected] or we can be reached by phone at 480-558-8588. XTC Power Products A Division of XTC Motorsports LLC 925 N McQueen RD. #101 Gilbert AZ 85233 480-558-8588 www.xtcpowerproducts.com Copyright © 2016 XTC MOTORSPORTS LLC All Rights Reserved