Preview only show first 10 pages with watermark. For full document please download

Uno-pm80 Panel Mount Kit For Uno-3000 Series

   EMBED

Share

Transcript

Packing List Installation Before you begin installing, please make sure that the following materials have been shipped: • Small PE bag with M4* 12 screw--- x4 • Mounting Brackets x2 • This (Startup) manual If any of these are missing or damaged, contact your distributor or sales representative immediately. Panel & Wall Mounting UNO-PM80-AE & UNO-WM80-AE To mount the chassis to a rack, use the two mounting brackets in the accessory package on the front side of the chassis.To mount the chassis on wall, use the two mounting brackets in the accessory package on the rear side of the chassis. Dimensions Stand Mount 30.00 5.50 234.00 0.00 228.50 6.50 0.00 20.00 8.85 0.00 Figure 1: Panel Mount Bracket M4 Screws 205.25 234.00 28.75 0.00 SCALE 1.000 Wall/Panel Mount 22.00 175.00 153.00 16.60 8.60 0.00 0.00 Figure 2: UNO-3000 Series Panel Mount Bracket 0.00 18.00 157.00 175.00 0.00 11.75 25.00 Notes For more information on this and other Advantech products, please visit our websites at: http://www.advantech.com/eAutomation For technical support and service: http://www.advantech.com/support/ This manual is for UNO-PM80, UNO-SM80, UNO-WM80 Part No. 2003001801 1st Edition July 2010 1 Startup Manual Figure 3: Wall Mounting Bracket (Left) All product specifications are subject to change without notice. STARTUP MANUAL UNO-PM80 Panel Mount Kit for UNO-3000 Series UNO-SM80 Stand Mount Kit for UNO-3000 Series UNO-WM80 Wall Mount Kit for UNO-3000 Series Installation (continued) Stand Mounting UNO-SM80-AE UNO-SM80-AE is used for Stand Mounting the UNO3000 Series. To stand the chassis on a desk, use the two stand mounting brackets on the both side of the chassis. Figure 4: Wall Mounting Bracket (Right) Mounting Caution Because the heat transfer mechanism is designed close to the left side of system, make sure not to attach the left side of the UNO chassis to the wall or ground. It may cause the system to hang due to poor heat dissipation. Instead, try to allow some space on the left side of UNO chassis. Figure 6: Screw Location on Front of Stand Kit Figure 7: Screw Location on Rear of Stand Kit Figure 5: Reserve Space After Panel/Wall Installation Note: The UNO-3000 series is fanless and depends on the heat sink to transfer heat. The procedure for installing the heat-sink on the main board is complex. Hence, please don't try to move the main board from the chassis and backplane. (If you uninstall the main board and cannot install it correctly back to chassis, the system may not be able transfer heat and will crash) 2 Startup Manual Figure 8: Fasten Screw on Left Side of Chassis All product specifications are subject to change without notice.