Transcript
[ USB 2.0 Hub Driver Installation Guide for Win XP ] In order to install the USB 2.0 Hub driver properly, you need to update the driver of USB 2.0 PCI host adapter first. Please follow the procedures below to update the driver : First, please insert the diskette into the floppy disk drive. Then click on the items in the following sequence : “Start”, “Control Panel”,
Fig. 1
“System”,
“Hardware”,
“Device Manager”
“Universal Serial Bus Controllers”,
Fig. 2 “Driver”,
“Update Driver”
“NEC PCI to USB Enhanced Host Controller”
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10 Now, the drivers are installed completely. Please click on “Driver File Details ..” to check if the drivers are installed properly. The window should look like the following picture.
Fig. 11 Please remove the diskette then reboot your computer. Once the computer goes steady, connecting your USB 2.0 Hub to your computer.
Fig. 12
Fig. 13
Fig. 14 Please check if your USB 2.0 Hub looks like the following picture.
Fig. 15 You are now ready to use your USB 2.0 Hub.
[ USB 2.0 Hub Driver Installation Guide for Win Me ] In order to install the USB 2.0 Hub driver properly, you need to update the driver of USB 2.0 PCI host adapter first. Please follow the procedures below to update the driver : First, please insert the diskette into the floppy disk drive. Then click on the items in the following sequence : “Start” , “Settings”,
“Control Panel” ,
“System” ,
“Device Manager”
Fig. 1
“Universal Serial Bus Controllers”, “Driver” , “Update Driver”
“NEC PCI to USB Enhanced Host Controller”
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11 Now, the drivers are installed completely.
Please click on “Driver File Details ..” to check if the drivers are installed properly. The window should look like the following picture.
Fig. 12
Please remove the diskette then reboot your computer. Once the computer goes steady, connecting your USB 2.0 Hub to your computer. You are now ready to use your USB 2.0 Hub.
Fig. 13
