Transcript
LIGHT OPERATION Located on the top of the light is the Function Button. Double press to turn on. A single press will then cycle between pulsing and constant modes. Press and hold the Function Button to turn off. When the Trace or TraceR turns off, the lens will display the battery level of the light for a few seconds.
LED
BATTERY %
GREEN
100 - 50
AMBER
50 - 25
RED
25 - 5
RED FLASH
5 - EMPTY
OPTIMISED MODE SELECTOR (OMS) When the light is turned off, press and hold the Function Button. After 3 seconds the OMS selection will start. The light will flash indicating the number of the mode selected (i.e. 2 flashes for mode 2).
PROGRAM
MODE CONSTANT
FLASH
1
3hrs
6hrs
2
6hrs
12hrs
3
12hrs
24hrs
USB CHARGING With the light turned off, plug the USB cable into the device that you wish to charge your light from. Carefully roll back the silicone ring where the USB symbol is printed and insert the USB cable provided. The light will flash green to indicate charging and will show a constant green light when charged. USB devices charge at different rates, the Trace should charge in around 2.5 hours.
IMPORTANT Once charging is complete make sure the silicone tab is replaced correctly to ensure no water ingress. If the cover is not properly installed, in severe conditions the Trace and TraceR USB charging port could be subjected to water ingress. For a good water tight seal and ease of correct installation, use a lubricant such as petroleum jelly or silicone grease on the areas shown on the illustration (A,B). Be sure to lubricate all faces of section B.
A
B
TRACE FITTING Attach the non-tabbed end of the silicone band to the bracket. Place the bracket onto your handle bar. Pull the tab under the handlebar and attach to the other side of the bracket. Simply click the Trace into the bracket making sure all is secure. WARNING - Make sure that brake and gear cables cannot catch on or interfere with the light or the bracket.
TRACER FITTING TraceR Fitting Loop the non-tabbed end of the silicone band over the bracket as shown. Place the bracket against the seatpost, pull the silicone band round the post and clip over the tab to hold in place.
Support the bracket and press the TraceR firmly in place as shown.
QUICKSTART GUIDE READY, SET UP, RIDE
TRACE & TRACER
MAINTENANCE
WARNING
Inspect and test your light before every ride.
Exposure Lights are very powerful lighting systems. Always take care when operating. Do not look directly into the light. This may cause serious injury. Do not shine directly at others.
Keep your Exposure Light clean, and the lenses free of dirt. The lenses are made of hi-tech resin but can be scratched. Be careful when cleaning any mud or dirt from the lens. Never use a high pressure spray or hose on your Exposure Light. Do not use harsh abrasive or corrosive materials to clean your Exposure Light.
Exposure Lights / Ultimate Sports Engineering Ltd. accept no liability for any injuries or other damages arising from the use of their product in any circumstances.
Follow all charging instructions. If the unit is being stored for long periods, please ensure the battery is periodically charged fully. We suggest once every month. The same applies to support cell batteries.
TRACE - TRACER ACCESSORIES Twin Helmet Mount Saddle Rail Bracket (TraceR only) Beacon 1
We design them. We make them. We are here to help. If you are experiencing any problems with your Exposure Light or accessories please contact us directly at: Service: +44 (0)1798 839300
[email protected] Alternatively contact your Exposure Dealer/ Distributor check web for details: www.exposurelights.com
For more information please visit: exposurelights.com
