Preview only show first 10 pages with watermark. For full document please download

Usb Device Application Kit Quick Start Guide

   EMBED

Share

Transcript

1 Verify kit contents USB Device Application Kit Board Quick Start Guide USB Device Application Kit Quick Start Guide Flat ribbon 16-pin cable USB Device Application Kit This Quick Start Guide USB cable 2 Connect hardware to development board a Connect your Development board to the USB Device Application Kit board via the provided flat ribbon 16-pin cable. Connect one end of the cable to the USB Device Application Header in your Development board (see table) b Connect the other end in header X1 of the USB Device Application Kit board c Connect the USB cable to the connector on the USB Application Kit board a Note: The male connector on the development board is not polarized. The red cable in the flat ribbon and the triangle in the board denote pin 1 Development Board ConnectCore 9P 9360 ConnectCore 9C/Wi-9C b USB Device Application Header X25 P32 c Development Board 3 Download documentation a To obtain a materials lists and installation instructions specific to your platform, go to http://www.digi.com/support b From the “Select a Product” drop down box, select “Application Kits” 4 What’s next? Open the User Manual that matches your embedded operating system. It contains instructions for installation and usage of the USB Device Application Kit drivers and software Shift © 2008 Digi International, Inc. Digi, Digi International, Inc., and the Digi logo are trademarks or registered trademarks of Digi International, Inc., in the United States and other countries worldwide. All other trademarks are property of their respective owners.