Transcript
USB Power Bank with Solar Charger MB-3615
Package Contents 1 x charger MB3615 with solar panel 1 x USB charging cable 6 x changeable connectors 1 x carabiner 1 x car charger For specific models like iPhone, iPod, iPad, Samsung Galaxy Tab and other devices, you can use the connectors included or alternatively you can use the original charging cable supplied with your device
Precautions before use Make sure the voltage of your device ranges between 4.5V to 5.5V Please read these instructions carefully as incorrect use of Li-Polymer batteries may lead to dangers such as overheating, fuming, catching fire. • Do not disassemble or open the charger • Do not throw or knock • Keep away from children • Make sure the solar panel are clean and free of debris for optimum charging • MB3615 is splash proof, but should not be submerged fully under water. Do not leave unit in the car or where temperatures could potentially exceed safe operating conditions for the internal battery (max Temperature = 45ºC). How to recharge your charger MB3615 The charger has a li-polymer battery inside to store the power, you can charge MB3615 by mains charger or by the solar panel. The charger can be charged either through solar energy or through a USB socket (computer, car charger, AC/DC charger...). The charger can be re-charged more than 800 times. The battery charge level can be checked by pressing the ON/OFF button briefly, there are 3 blue LEDs to indicate the charge level(low, medium, high)
1. Solar Energy • MB3615 has a mono-crystalline solar panel. • Just leave the solar panel exposed to sunlight and it will automatically start to charge, it can be conveniently attached onto any bag (School bag, computer bag, backpack, golf bags, beach bags...) using the carabiner supplied with the charger. • One LED on the panel will illuminate, indicating the MB3615 is being charged. The lighting intensity will indicate the efficiency level of solar energy. Fully charging MB3615 with solar energy takes approximately 15 hours with optimal daylight conditions. Charging efficiency will be affected by daylight conditions.. 2. USB charging MB3615 can be recharged from any USB socket of a computer (laptop or desk computer): • Unfold the built-in USB cable located at the back of the unit (input 5V) • Then plug in the USB into a USB socket (computer, wall charger, car charger etc) • The LEDs on the panel will illuminate indicating MB3615 is being charged. It will turn off automatically as soon as the unit is fully charged. Fully charging through USB port takes 5 to 7 hours depending on the USB source.
How to recharge your device with MB3615 Most 5V devices can be charged: eg. mobile phones, PDA, tablets, Bluetooth headsets, MP3 players, and some models of digital cameras can be recharged This can be achieved by using either the connectors supplied with MB3615 or the USB cable supplied with your device. There are 2 x USB charging ports on MB3615, so that devices can be charged simultaneously.
*Make sure the internal battery of MB3615 is fully charged. * The battery charge level can be checked by pressing the ON/OFF button briefly, there are 3 blue LEDs to indicate the charge level (low, medium, high) *You can use either the charging cable supplied with MB3615 (changeable connectors included) or by using the original USB charging cable supplied with your device *Plug in the USB cable into one of the USB output ports *Press the ON/OFF key once to switch on your MB3615 Power: Charging will start automatically after a few seconds and you can see it from the charging indicator on your device. It is normal that the LED lights of the MB3615 do no light on while charging your device for power management optimization. When your device is fully charged or disconnected, MB3615 will automatically switch off. How to use the LED Flashlight Just press 5 seconds on the ON/OFF key to switch on the LED Flashlight Technical Specifications • Battery Capacity: 4000 mAh, Li-Polymer • Rated input: 5 V= 800 mA • Solar panel: 5V = 320 mA Max (optimum conditions) • Rated output: 5 V = 2.1A Max • Working temperature: 0º C – 45º C • Net weight: 162 g Safety features: Over-charging, short-circuit and over-discharging protection Distributed by: TechBrands by Electus Distribution Pty Ltd 320 Victoria Rd Rydalmere NSW 2116 Australia
