Transcript
MOBOT® Swift 2nd Gen Electric Scooter
USER MANUAL PLEASE CAREFULLY READ THE USER MANUAL AND WARRANTY BOOK BEFORE USING
WARNING Whenever you ride the MOBOT® Swift 2nd Gen electric scooter you might risk having serious injury from collisions, falls or loss of control. To ride safely, YOU MUST READ AND FOLLOW ALL INSTRUCTIONS AND WARNINGS STATED IN THIS MANUAL. This manual includes basic operational instructions for the MOBOT® Swift 2nd Gen electric scooter. It does not cover any situations where injury or death may occur. OPERATORS MUST USE GOOD JUDGMENT AND COMMON SENSE TO DETECT AND AVOID HAZARDS AND DANGERS that they may encounter when riding the MOBOT® Swift 2nd Gen electric scooter. By using the MOBOT® Swift 2nd Gen electric scooter, it deems that you accept the inherent risks of operating this product.
CONTENTS MAIN PART
4
SAFETY
5
PRODUCTS Folding Stage Folding Steps Opening Steps
7 8 9
RIDING OPERATION
10
PRODUCT OPERATION
11
BATTERY and CHARGER
12
MAINTENCE
13
GENERAL TROUBLESHOOTING
13
PRODUCT SPECIFICATION SHEET
14
PRODUCT WARRANTY
15
MAIN PARTS
SAFETY 1.
Please read the instruction manual carefully before using the scooter, do not lend it to anyone who is/or unclear on the uses of the scooter.
2.
The product is recommended for adults (18 years old and above) and is not suitable for minors age (below 12 years old).
3.
Please wear your safety helmet and other protective equipment when riding.
4.
Do not ride in traffic lane or unsafe roads that is breaking the local traffic rules and regulations.
5.
Please exercise in wide areas, and ride after skilled manipulation.
6.
Do not attempt any dangerous actions like riding single-handedly.
7.
Always keep your feet on the scooter platform.
8.
Do not attempt to ride the scooter on stairs that are above 3 cm. It may result in vehicle overturn, causing injuries and/or damages to the rider and/or scooter.
9.
The maximum speed limit for MOBOT ® Swift 2nd Gen is 35 Km/h. For your safety, please maintain the riding speed at 20 Km/h.
10. When travelling at night, please limit the speed within 15 Km/h or less and turn on the headlights. 11. For safety reasons, do not ride the scooter in bad weather conditions such as heavy downpours and high winds. 12. Do not use the scooter when outdoor temperature is lower than 0ºC. 13. Please slow down or avoid using the scooter when riding in poor road conditions such as oily or slippery road surfaces. 14. Please adjust the handlebar according to your height to ensure a safe and comfortable riding. 15. To avoid damages to the electrical parts of the vehicle, do not immerse the scooter in water with depth of more than 4 cm. Do not wash it with pressurized water.
16. Please check the scooter brakes, headlight, rear light and horn is functional, as well as the steering of the handle bar.
17. Unsuitability of using this product may be subjected to the old age, pregnant women, disability, after-consumption of alcohol and drugs.
18. Please do not ride on unauthorized areas that is regulated by the government. For the safety of yourself and other road users, always follow on the traffic rules and signs.
19. Slow down the scooter when travelling on wet slippery surfaces to avoid making unnecessary emergency brake.
20. Charge the battery under room temperature (20°C), leave the battery uncovered to allow better cooling of the battery preventing it from over-heating.
21. Do not dispose the old battery that is harmful to the environment, instead you can return to us for recycling.
22. It is recommended to go for the first maintenance check for the first 2 (months) and subsequently for the every 3 (months) for maintenance check.
23. Please do not modify any parts of the scooter including the engine and tyres. 24. Please do not attempt to modify the readings or detach the LCD panel as designed by the company.
25. Please keep the scooter out of reach from children. 26. Each MOBOT® Swift 2nd Gen electric scooter is equipped with a special lithium polymer battery and special smart charger. These accessories that come with each scooter have a dedicated number, do not use the chargers from other brands. Damages caused by using inappropriate battery chargers is not under usual product warranty.
PRODUCTS Folding Stage
A- Unfolded
B- Folded Handlebar
C- Fully Folded
PRODUCTS
Folding Steps
PRODUCTS
Opening Steps
RIDING OPERATION
Before Ride Procedure 1. The normal air pressure of the front wheel tire should maintain within (240-250) kPa, rear wheel tire should maintain within (250-260) kPa. Please check the tire frequently for any defects. (Important) Deflated tires will affect the steering process of the scooter. 2. Check if the accelerator and brakes are functioning properly. 3. Check if the headlight and rear light is functioning properly. 4. Check if the handles are steering smoothly from left to right. During Ride Procedure 1. Please do not ride in single-handle! For first user, please practice on an open area before proceeding to pedestrian road. 2. When travelling on wet and slippery surfaces, avoid riding on high speed, making sharp turns and always keep a safe distance between other vehicles and pedestrians. 3. When travelling at night, always turn on the head and rear light. 4. During heavy downpour, do not ride on high flood level that will damage the motor and battery. 5. Please do not ride on unauthorized areas that is regulated by the government! After Ride Procedure 1. Turn off the power by pressing the off button beside the LCD Screen. 2. Always check on the remaining power of the battery, to ensure sufficient power for next use. 3. Always ensure that the scooter is park in stable and locked
PRODUCT OPERATION 1. Introduction of LCD Screen
1 2 3 4
5 6
7
1. Battery indicator
5. On/ Off Button
2. Speed indicator
6. Mode Button (Function button)
3. Per or Total Trip indicator
7. Thumb Throttle
4. Total or per Trip distance travel Switch 1) To turn on the electric scooter, press and hold the on/off button for 3 second. Speed 1) User could control the speed between 1km/h to 35km/hr by pushing the thumb throttle. Accelerate depend on how much force input to the thumb throttle.
Power/ Battery Display 1) The LCD Screen will show the amount of battery left after your ride. Distance 1) The LCD screen show the total distance per trip travel or the distance total trip travel. Head and Rear light 1) When travelling at night, please switch on the head and rear light. Brake 1) User can brakes the scooter by hold on to the brake lever which connected to the rear electric disk brake and front disk brake on the left. Start non-zero start function 1) Turn on the electric scooter 2) The scooter is equipped with non-zero start electric motor system and the brake will switch off the device. During the starting ride, please first go by your foot slide to let the scooter move then use the thumb throttle to use the function.
BATTERY AND CHARGER Each MOBOT® Swift 2nd Gen electric scooter is equipped with a special lithium polymer battery and special smart charger. These accessories that come with each scooter have a dedicated number, do not use the chargers from other brands. Damages caused by using inappropriate battery chargers is not under usual product warranty.
Battery 1) When charging the battery, the LED turns red which means that charging is in progress. When it is in “green” it means battery is fully charged. 2) If the red light does not turn green after continuous charging, please visit our service center. 3) For the first 5 uses, please charge the battery for at least 10 hours before use. 4) Please do not charge the battery for more than 12 hours. 5) Charge the battery in area temperature of (0~45)°C, the ideal temperature for charging will be 25°C. 6) Please charge the battery once every month, if not in use for a long period of time. 7) Do not operate motor while charging. (Important!) 8) Avoid direct contact of the battery from flames and direct sun exposure.
9) Avoid water or other liquid to be in contact with the battery. 10) We recommend you to go for maintenance once every 3 months to check on the body and parts of the scooter.
Charging Description 1) Open the charging hole under the rubber protective cover and plug in the charger connector. 2) Connect the charger plug into the power socket. 3) The charger light turns red when charging is in progress. Charger light turns green when battery is fully charged. 4) Please close the main power of the scooter, and charge the scooter around 48V. 5) Please always check whether there is still remaining power left in the battery the next trip. 6) The company provides dedicated charger which has a charging protection function, when the battery is 100% charged, the charger will automatically stop charging. Charging time is no more than 3 hours. 7) Water immersion, collisions, and other abnormal factors will lead to charger damage, which is not covered under warranty.
MAINTENANCE Due to the likelihood of breakdown of the electric scooter usually within 1 year, in order to allow convenience and ease of maintenance. The company has implement 1 year of free warranty plan. Proper use and maintenance of the scooter will prolong the lifespan of the scooter. We recommend you to send the scooter for maintenance once every 3 months to check on the brakes and the battery functionality. Lubrication Need every six months in folding hand clutch set using a small amount of lubricating oil or lubricant to do maintenance. Tire When the brake performance began to decline, can adjust the brake line regulator in order to achieve the required sensitivity. If the brake line after adjustment, the performance still poor, or still noise at the brake area, you need to find the dealers for the replacement of brake pads. Battery The product is equipped with lithium battery can repeat charging at least 2 year, 800 times. When each time with electric range is too short, lithium batteries need to be replaced.
GENERAL TROUBLESHOOTING
Checking List 1) Please check the following actions do or not if the scooter cannot work 2) Power switch is turned on 3) Display shows remaining power stand more the limited 4) Brake lever is not stand at the working position 5) All sockets and connectors are clean and well connected.
PRODUCT SPECIFICATION SHEET
PRODUCT WARRANTY In normal use, if a part or parts of the electric scooters have any problems listed in the following form during the warranty period, please contact your local vendor or authorised reseller, we will provide a complete service as specified in the warranty book. Item
Quality problems
Warranty period
Service item
Motor
Under normal circumstances the motor cannot be used
One year
Free maintenance
Controller
Failures under normal use
One year
Free maintenance
Lithium Battery
Under normal circumstances cannot be charged and discharged
One year
Free maintenance
Body structure
Failures under normal use, such as deformations and fractures
One year
Free maintenance
Charger
Failures under normal use
Six month
Free maintenance
UBHI
Cannot be used under natural conditions (Excluding the impact forces and external damages)
Six month
Free maintenance
(uniblock human interface-display)
Note: Please follow the correct way to use this product, the company will not be responsible for parts damaged and other damages caused by misusing. PRODUCT WARRANTY In warranty period, if the malfunction and damage caused by the following reasons, it will not be within the scope of product warranty: 1. Inappropriate maintenance and repair that are not in accordance with the instruction manual. 2. Use of the electric scooter for other purposes such as performing dangerous acts which result in damages or functional failures. 3. Using any of the external factory components. 4. Disassembling the scooter without contacting the local reseller. 5. Wrongly usage causing traffic accidents or accidental collision damage to the product body and the parts. 6. Product wear and tear. MOBOT PTE LTD 62 Ubi Road 1, #03-19 Oxley Bizhub 2, Singapore 408734 Tel: 65382816 | Fax: 65382817
www.MOBOT.sg
